Results 111 to 120 of about 120,363 (295)
Dynamic scaling for 2D superconductors, Josephson junction arrays and superfluids
The value of the dynamic critical exponent $z$ is studied for two-dimensional superconducting, superfluid, and Josephson Junction array systems in zero magnetic field via the Fisher-Fisher-Huse dynamic scaling.
A. F. Hebard +76 more
core +1 more source
Controlled syntheses of lanthanide coordination polymers based on the dihydroxybenzoquinone (DHBQ) organic linker afforded large single crystals of Ln‐DHBQ CPs (Ln = Yb, Nd). A novel structural variant of Yb‐DHBQ is identified by means of single crystal diffraction analysis.
Marina I. Schönherr +7 more
wiley +1 more source
Voltage Collapse Avoidance by using STATCOM
This paper deals with modelling and simulation of STATCOM in IEEE 14 bus System with Induction Motor load for avoiding voltage collapse. Three Phases to ground fault is applied in predominant Induction motor load bus for voltage collapse analysis.
Tandra Sutradhar +2 more
openaire +1 more source
Prediction of Voltage Collapse in Electrical Power System Networks using a New Voltage Stability Index [PDF]
The numerous power system blackouts in the past decade and in recent times attest to the fact that more work still needs to be done to tackle the problem of voltage instability and the resultant voltage collapse.
Awelewa, A. A. +3 more
core
Electroactive Metal–Organic Frameworks for Electrocatalysis
Electrocatalysis is crucial in sustainable energy conversion as it enables efficient chemical transformations. The review discusses how metal–organic frameworks can revolutionize this field by offering tailorable structures and active site tunability, enabling efficient and selective electrocatalytic processes.
Irena Senkovska +7 more
wiley +1 more source
Long-Term Voltage Stability Assessment of an Integrated Transmission Distribution System
Long-term voltage stability assessment (VSA) of independent transmission (T-VSA) and distribution (D-VSA)systems have been studied since long to estimate load margins. However, their impacts on each other have been neglected due to simplified assumptions
Ajjarapu, Venkataramana, Singhal, Ankit
core +1 more source
3D‐Printed Sulfur‐Derived Polymers With Controlled Architectures for Lithium‐Sulfur Batteries
Rheology‐guided formulation design for direct ink writing enables the fabrication of 3D sulfur copolymer cathodes with controlled architectures for lithium‐sulfur batteries. The printed electrodes exhibit multiscale porosity and high sulfur utilization, delivering enhanced electrochemical performance compared to conventional cast electrodes.
Bin Ling +7 more
wiley +1 more source
This paper proposes a distributed parameter-based voltage stability index (DPVSI) for assessment of voltage stability of the power system. Proposed index incorporates the effects of distributed parameters of transmission line to predict voltage collapse.
Pradeep Singh, Rajive Tiwari
doaj +1 more source
A new experimental methodology and test system is proposed to assess the wall pressure due to the high-voltage underwater Spark-generated bubble. In the methodology, a Hopkinson bar is used as the sensing element and the pressure signal is obtained based
Xiongliang Yao +3 more
doaj +1 more source
Colossal magnetocapacitance and scale-invariant dielectric response in phase-separated manganites
Thin films of strongly-correlated electron materials (SCEM) are often grown epitaxially on planar substrates and typically have anisotropic properties that are usually not captured by edge-mounted four-terminal electrical measurements, which are ...
A Biswas +35 more
core +1 more source

