Results 251 to 260 of about 4,908,941 (325)
Some of the next articles are maybe not open access.
A Bridge-Less Cuk-Derived Voltage Doubler Based Power Factor Correction Rectifier
2022 IEEE 1st Industrial Electronics Society Annual On-Line Conference (ONCON), 2022In this paper, a bridge-less (BL) Cuk-derived voltage doubler based power factor correction (PFC) rectifier is proposed. The voltage gain of this converter is doubled through the use of two Cuk converter cells whose inputs are organized in parallel and ...
Patil Rahul D, S. P
semanticscholar +1 more source
An SC Voltage Doubler With Pseudo-Continuous Output Regulation Using a Three-Stage Switchable Opamp [PDF]
This paper presents a switched-capacitor voltage doubler using pseudo-continuous control (PCC). The proposed PCC does not require extra power transistor to continuously regulate the output of the doubler, thereby saving chip area. The PCC also allows the
Philip Kwok Tai Mok, Lee Hoi, P K T Mok
exaly +2 more sources
Unidirectional Three-Phase Voltage-Doubler SEPIC PFC Rectifier
IEEE transactions on power electronics, 2021This article reports the theoretical analysis and experimental results for a three-phase high power factor SEPIC-type rectifier operating in discontinuous conduction mode (DCM).
P. J. Costa +3 more
semanticscholar +1 more source
Switching Noise and Shoot-Through Current Reduction Techniques for Switched-Capacitor Voltage Doubler [PDF]
Switching noise and shoot-through current reduction techniques for switched-capacitor voltage doublers based on cross-coupled structure are presented.
Lee Hoi, P K T Mok
exaly +3 more sources
A voltage-sensorless PFC voltage doubler
2012 15th International Power Electronics and Motion Control Conference (EPE/PEMC), 2012This paper proposes a voltage-doubling rectifier, or voltage doubler, with power factor correction (PFC) function and without voltage sensors on the ac and dc sides. The rectifier only uses an ac-side current sensor. The voltage information required for the PFC control is obtained from the ac-side current and its derivative in the on and off durations ...
Junichi Yamamoto +2 more
openaire +1 more source
A high-efficiency CMOS voltage doubler
IEEE Journal of Solid-State Circuits, 1998A charge pump cell is used to make a voltage doubler using improved serial switches. A complete power efficiency theory is presented which fits the measurements. The importance of capacitors is shown with plots of power efficiency versus load and stray capacitors.
Pierre Favrat +2 more
openaire +2 more sources
A breakdown voltage doubler for high voltage swing drivers
Proceedings of the IEEE 2004 Custom Integrated Circuits Conference (IEEE Cat. No.04CH37571), 2004A novel breakdown voltage (BV) doubler is introduced that makes it possible to generate high output voltage swings using transistors with low breakdown voltages. The timing analysis of the stage is used to optimize its dynamic response. A 10 Gb/s optical modulator driver with a differential output voltage swing of 8 V on a 50 /spl Omega/ load was ...
Sam Mandegaran, Ali Hajimiri
openaire +2 more sources
IEEE transactions on power electronics, 2020
In photovoltaic applications, many previous research works have focused on pulsewidth modulation (PWM) resonant converters in order to achieve a high efficiency with a wide input voltage range.
Jongwan Kim +4 more
semanticscholar +1 more source
In photovoltaic applications, many previous research works have focused on pulsewidth modulation (PWM) resonant converters in order to achieve a high efficiency with a wide input voltage range.
Jongwan Kim +4 more
semanticscholar +1 more source
Design of Maximum-Efficiency Integrated Voltage Doubler
2007 IEEE International Symposium on Circuits and Systems (ISCAS), 2007In this paper, an algorithm and the analytical expressions to be used for the design of maximum-efficiency integrated charge pumps based on the voltage doubler architecture are presented. Starting from basic considerations on charge transfer, the proposed methodology allows adequate choice of the stage number and of the size of all charge pump elements,
Alessandro Cabrini +2 more
openaire +2 more sources
IEEE transactions on industry applications, 2020
The interleaved voltage-doubler boost converter strategy exhibits a very good performance, namely, in a low conduction loss, an acceptable switch stress, a fast transient response, and a very high power density. However, the bottleneck for application in
Chung-Yi Li +2 more
semanticscholar +1 more source
The interleaved voltage-doubler boost converter strategy exhibits a very good performance, namely, in a low conduction loss, an acceptable switch stress, a fast transient response, and a very high power density. However, the bottleneck for application in
Chung-Yi Li +2 more
semanticscholar +1 more source

