Results 261 to 270 of about 4,908,941 (325)
Some of the next articles are maybe not open access.
Voltage Doubler Design for RF Energy Harvesting System
2020 7th International Conference on Smart Structures and Systems (ICSSS), 2020This paper deals with the design of Voltage Doubler circuit in an energy transformation network for Radio Frequency (RF) energy generating at 875 MHz The main function of the energy transformation system is to transform the radio frequency signals into ...
T. Sathiyapriya +4 more
semanticscholar +1 more source
A Low Ripple Current Mode Voltage Doubler
2015 IEEE 18th International Symposium on Design and Diagnostics of Electronic Circuits & Systems, 2015Experimental results of a fully integrated low ripple charge pump voltage converter are presented. The pump is a current mode voltage doubler with a novel parasitic capacitance precharge mechanism for output voltage ripple reduction. A prototype of the pump was designed and fabricated in 130 nm CMOS process.
Andrzej Grodzicki, Witold A. Pleskacz
openaire +1 more source
A High Voltage Gain Quadratic Boost Converter using a Voltage Doubler and Voltage-Lift Technique
2020 IEEE International Conference on Power Electronics, Smart Grid and Renewable Energy (PESGRE2020), 2020A novel high voltage gain quadratic boost converter is proposed which is based on the voltage-lift technique and useof industrial applications including UPS (uninterrupted power supplies), PV (photovoltaic) systems, automobile HID lamps, fuel cells, etc.
Arpan Laha
semanticscholar +1 more source
A low-voltage voltage doubler without body effect
2008 9th International Conference on Solid-State and Integrated-Circuit Technology, 2008A voltage doubler, which avoids body effect and then improves rise time and efficiency even with 1 V power supply, is presented. This art is designed for word line boosting, using 0.18 um EEPROM technology. Not only the voltage doubler can work with capacitive load normally, but also it can supply load current and achieve higher efficiency.
null Ming Li +3 more
openaire +1 more source
Performances Comparison of Shottky Voltage Doubler Rectifier to support RF Energy Harvesting
2020 IEEE International Conference on Environment and Electrical Engineering and 2020 IEEE Industrial and Commercial Power Systems Europe (EEEIC / I&CPS Europe), 2020Electromagnetic waves are increasingly the preferred source for charging the battery of wireless sensor nodes. Given the small amount of harvestable energy, much work has been proposed to optimize the energy efficiency of radiofrequency energy converter ...
Alex Mouapi, N. Hakem, N. Kandil
semanticscholar +1 more source
Yield optimization of a RSFQ voltage doubler
Journal of Low Temperature Physics, 1997The centers-of-gravity optimization method has been applied to optimize a complex circuit consisting of a dc/SFQ-converter and RSFQ voltage doubler in order to obtain maximum parameter margins. As a result, the margins of all circuit parameters have been enlarged to at least ±35%. This improves the yield of the circuit fabrication process. On the other
Erik Romanus +3 more
openaire +1 more source
A Single-Stage Dual-Output Regulating Voltage Doubler for Wireless Power Transfer
IEEE Journal of Solid-State CircuitsA single-stage dual-output regulating voltage doubler (DOVD) is proposed for biomedical wireless power transfer (WPT) systems. Derived from the full-wave voltage doubler (VD) topology, it achieves ac-to-dc rectification and dual-output voltage regulation
Tian-Qi Lu, K. Makinwa, Si-Jun Du
semanticscholar +1 more source
IEEE Journal of Emerging and Selected Topics in Industrial Electronics
This article provides the modified pulsewidth modulation (MPWM) gating approach established in an interleaved dc–dc converter made of inductor–capacitor (LC) components and including a voltage doubler at the secondary. The MPWM technique is used in an LC-
K. Mathuria, H. Tiwari
semanticscholar +1 more source
This article provides the modified pulsewidth modulation (MPWM) gating approach established in an interleaved dc–dc converter made of inductor–capacitor (LC) components and including a voltage doubler at the secondary. The MPWM technique is used in an LC-
K. Mathuria, H. Tiwari
semanticscholar +1 more source
IEEE transactions on power electronics, 2019
This paper proposes a quasi-resonant boost half-bridge dc–dc converter with high power conversion efficiency and a wide input voltage range for a photovoltaic micro-inverter.
Hyeon-Seok Lee, Jae-Jung Yun
semanticscholar +1 more source
This paper proposes a quasi-resonant boost half-bridge dc–dc converter with high power conversion efficiency and a wide input voltage range for a photovoltaic micro-inverter.
Hyeon-Seok Lee, Jae-Jung Yun
semanticscholar +1 more source
Improved active‐diode circuit used in voltage doubler
International Journal of Circuit Theory and Applications, 2012SUMMARYAn improved active‐diode circuit, which makes use of positive feedback to achieve fast on/off transition, is presented in this paper. The proposed active‐diode circuit can be embedded into a voltage doubler to replace the commonly used dead‐time circuit and to eliminate reverse current. In addition, the relationship between oscillation frequency,
Jingbin Jia, Ka Nang Leung
openaire +2 more sources

