Results 1 to 10 of about 564,978 (190)

Low-Voltage Stress Buck-Boost Converter With a High-Voltage Conversion Gain [PDF]

open access: yesIEEE Access, 2020
The conventional buck-boost converter has the advantages of simple structure, low cost, and the capability to achieve both voltage step-up and down. However, due to the negative impacts of the parasitic parameters of the device, the voltage conversion ...
Binxin Zhu   +4 more
doaj   +2 more sources

Multistage converter with reduced switch voltage stress and diode current stress

open access: yesIET Power Electronics
The utilization of switched inductors, involving parallel charging and series discharging of inductors, is extensively embraced in diverse DC–DC converters for attaining high voltage gain; nevertheless, the stress on switch voltage and diode current ...
M. S. Bhaskar   +4 more
doaj   +2 more sources

Modified LUO High Gain DC-DC Converter With Minimal Capacitor Stress for Electric Vehicle Application

open access: yesIEEE Access, 2021
The vigorous growth of electric vehicles in the field of automobile paves the way for the development of dc-dc converter. A novel high gain super Luo dc-dc converter is proposed in this article.
J. Divya Navamani   +4 more
doaj   +1 more source

Non-Isolated High Gain Quadratic Boost Converter Based on Inductor’s Asymmetric Input Voltage

open access: yesIEEE Access, 2021
This paper introduces the concept of inductors asymmetric input voltage to derive a new high voltage gain converter. The proposed converter has continuous input, positive output, and high-power density features suitable for renewable energy applications.
S. V. K. Naresh   +2 more
doaj   +1 more source

Applying LCC Compensated Primary Topology Utilizing Switches for Transmitters With Inter-Coupling in a Wireless Power Transmission System

open access: yesIEEE Access, 2022
LCC compensation network is a commonly used primary compensated topology for wireless power transmission. In this paper, we investigate the LCC primary topology utilizing switches for two transmitters with strong inter-coupling.
Shaocong Zhou   +4 more
doaj   +1 more source

A new topology of the switched-inductor/capacitor quasi Z-source inverter with ability of uplifted-boost [PDF]

open access: yesInternational Journal of Industrial Electronics, Control and Optimization, 2020
In this paper, a new topology of switched-inductor/capacitor quasi impedance source inverter is suggested, which in comparison with the other topologies possesses higher boost voltage inversion at high modulation index and low shoot through duty cycle ...
Alireza Karbalaei   +2 more
doaj   +1 more source

An Embedded Half-Bridge Γ-Z-Source Inverter with Reduced Voltage Stress on Capacitors

open access: yesEnergies, 2021
In this paper, an embedded half-bridge Z-source inverter based on gamma structure is proposed. In contrast with the classical half-bridge inverter, the proposed inverter can generate zero voltage levels in output. High voltage gain and low voltage stress
Hamed Mashinchi Maheri   +5 more
doaj   +1 more source

An Improved Non-Isolated Quadratic DC-DC Boost Converter With Ultra High Gain Ability

open access: yesIEEE Access, 2023
This paper introduces an improved quadratic DC-DC boost converter to provide an ultra-high level voltage gain with the switched-capacitor cell based structure.
Nafis Subhani   +5 more
doaj   +1 more source

The Influence of ZnO Layer Thickness on the Performance and Electrical Bias Stress Instality in ZnO Thin Film Transistors [PDF]

open access: yes, 2020
University of Buea supported the first author during the writing of this manuscript Open access articleThin Film Transistors (TFTs) are the active elements for future large area electronic applications, in which low cost, low temperature processes and
Cross, R. B. M.   +2 more
core   +2 more sources

Zero‐voltage‐switching buck converter with low‐voltage stress using coupled inductor [PDF]

open access: yesIET Power Electronics, 2016
This study presents a new zero‐voltage‐switching (ZVS) buck converter. The proposed converter utilises a coupled inductor to implement the output filter inductor as well as the auxiliary inductor which is commonly employed to realise ZVS for switches.
Chen, Guipeng   +4 more
openaire   +2 more sources

Home - About - Disclaimer - Privacy