Results 91 to 100 of about 26,103 (305)
Effect of Oxygen Content on Surface and Subsurface Integrity During Turning of Ti–6Al–4V
Advanced Engineering Materials, EarlyView.This study examines how oxygen content in the ambient atmosphere affects the surface and subsurface properties of Ti–6Al–4V during turning. Results show that oxygen does not influence surface roughness. However, machining in an extremely high vacuum‐adequate atmosphere increases surface hardness by up to 7.8% and induces compressive residual stresses ...
Benjamin Bergmann +3 more
wiley +1 more source
Oxide‐Free Titanium Coatings by Wire Arc Spraying in a Silane‐Doped Inert Atmosphere
Advanced Engineering Materials, EarlyView.A silane‐doped argon atmosphere enables the production of oxide‐free titanium coatings via twin‐wire arc spraying at ambient pressure. This innovative approach eliminates residual oxygen, creating process conditions that prevent oxidation and nitride formation.
Manuel Rodriguez Diaz +4 more
wiley +1 more source
Aerodynamics of vortex generators [PDF]
An experimental and theoretical study was undertaken of the separation delay and dramatic boundary-layer thinning that can occur in vortex-generator installations.
Breidenthal, Robert E., Jr. +1 more
core +1 more source
Correlations between Abelian Monopoles and center vortices
, 2017 We study the correlations between center vortices and Abelian monopoles for SU($3$) gauge group. Combining fractional fluxes of monopoles, center vortex fluxes are constructed in the thick center vortex model.
Deldar, Sedigheh +1 more
core +2 more sources
Advanced Engineering Materials, EarlyView.Collagen hydrolysate is evaluated as a sustainable binder for MgO‐C refractories. Its thermally induced cross‐linking and gas release lead to expansion and cracking in large bricks, but tailored batches with lignin, recyclates, or fine graphite improve the gas release while thermal treatment and stability.
Till M. J. Stadtmüller +8 more
wiley +1 more source
An experimental investigation of S-duct flow control using arrays of low-profile vortex generators [PDF]
An experimental investigation was undertaken to measure the effect of various configurations of low-profile vortex generator arrays on the flow in a diffusing S-duct.
Reichert, Bruce A., Wendt, Bruce J.
core +1 more source
Flow Control Over a Tractor-Trailer Using Vortex Generators [PDF]
, 2016 No abstract ...
Kontis, Konstantinos, Lo, Kin Hing
core
Multimodal Data‐Driven Microstructure Characterization
Advanced Engineering Materials, EarlyView.A self‐consistent autonomous workflow for EBSP‐based microstructure segmentation by integrating PCA, GMM clustering, and cNMF with information‐theoretic parameter selection, requiring no user input. An optimal ROI size related to characteristic grain size is identified.
Qi Zhang +4 more
wiley +1 more source
Design and Development of Vortex Generators on Cylindrical Tower
Modelling and Simulation in EngineeringThis work presents a numerical study on flow configurations and pressure distribution of cylindrical towers attached with different shapes of vortex generators.
Amnart Boonloi +2 more
doaj +1 more source
Flat-plate drag measurements with vortex generators in turbulent boundary layer [PDF]
Direct drag measurements were obtained on a flat plate with a spanwise row of vortex generators near the leading edge, to produce an array of stream wise vortices within the approaching turbulent boundary layer.
Mehrotra, S. C., Rao, D. M.
core +1 more source