Results 161 to 170 of about 5,236 (204)

Roottorin korjauksen hiilijalanjälki WAAM-menetelmällä

openaire   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Optimized Robotic WAAM

2022
This chapter summarizes a PhD thesis introducing a methodology for optimizing robotic MIG (metal inert gas) to perform WAAM (wire and arc additive manufacturing) without using machines equipped with CMT (cold metal transfer) technology. It tries to find the optimal MIG parameters to make WAAM using a welding robot feasible production technique capable ...
Aya Abd Alla Ramadan, Sherif Elatriby, Abd El Ghany, Azza Fathalla Barakat   +3 more
openaire   +1 more source

Investigation of Corrosion in WAAM Manufactured Materials

CONFERENCE 2022, 2022
Abstract To develop the commercial applicability of Wire-Arc Additive Manufacturing (WAAM), there is a crucial need to understand the corrosion behaviour of the fabricated materials for industry acceptance. It is well-known that WAAM process has a complex thermal process, resulting in unique microstructures and material surfaces.
null Aishwarya, Robert Shandro, Benoit Verquin, Liam Kok Chye, Quentin Petavy   +4 more
openaire   +1 more source

ON PROCESS STABILITY IN WAAM-CMT OF ALUMINUM ALLOYS

2023
Wire-arc additive manufacturing (WAAM) has become a cost-efficient metal additive manufacturing process. However, depositing aluminum with WAAM is challenging due to its sensitivity to heat input (linear energy density), which can cause undesirable surface topology waviness if not controlled.
Thien, Austen, Kelly, Kathryn M., Massey, Caroline E., Saldana, Christopher J.   +3 more
openaire   +1 more source

A study on the effect of shielding gases on the GMAW-WAAM process and performance of WAAM-deposited low-carbon steel

International Journal of Materials Research
Abstract Wire Arc Additive Manufacturing (WAAM) is a direct energy deposition-based additive manufacturing process that uses an arc welding power source to fabricate large-scale 3D components from wire feedstock.
Kumar Kanishka, Bappa Acherjee
openaire   +1 more source

Additive manufacturing using WAAM with AA5183 wire

Journal of Materials Processing Technology, 2018
Abstract The present study addresses wire arc additive manufacturing of AA5183 aluminium alloy using conventional gas metal arc welding deposition on 20 mm thick AA6082-T6 plate as support material. Microscopic examination demonstrates that the process is feasible, but can be further optimized to reduce gas porosity and hot cracking.
A. Horgar, H. Fostervoll, B. Nyhus, X. Ren, M. Eriksson, O.M. Akselsen   +5 more
openaire   +1 more source

Variability in the Height of Layers for Robotised WAAM Process

2022
Julia Wilk, Norbert Prokopiuk, Piotr Falkowski   +2 more
openaire   +1 more source

A review of WAAM for steel construction – Manufacturing, material and geometric properties, design, and future directions

Structures, 2022
Paul Shepherd, Jialuo Ding, Jian Qin
exaly  

A review on process planning strategies and challenges of WAAM

Materials Today: Proceedings, 2021
Satish Kumar Sharma, Dinesh W. Rathod
exaly  

Integrating robotic wire arc additive manufacturing and machining: hybrid WAAM machining

International Journal of Advanced Manufacturing Technology, 2023
Arif S. Malik, Hongbing Lu
exaly