Results 71 to 80 of about 65,337 (304)
Reproduction of stacking fault energy calculations from literature with a semi‐automated large language model‐assisted extraction procedure: extraction of simulation protocol, atomistic structures, computational parameters, and reported results, ontology alignment, knowledge graph construction and, finally, recomputation forvalidation.
Sepideh Baghaee Ravari +5 more
wiley +1 more source
Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar +7 more
wiley +1 more source
To obtain the mechanical energy of waves from arbitrary directions, the vibration absorbers of wave energy converters (WEC) are usually vertically axisymmetric.
Zhang Wanchao +4 more
doaj +1 more source
Low‐voltage FIB‐SEM tomography combined with a image preprocessing pipeline improves phase contrast and enables reliable machine‐learning segmentation of conductive networks in lithium‐ion battery electrodes. Structural descriptors are extracted from segmented images, done semimanually and automated, and compared.
Lisa Beran +6 more
wiley +1 more source
Research on Wave Energy Converters [PDF]
With the acceleration of the global warming process, the clean energy crisis is becoming serious; conventional energy is unlikely to solve the current crisis, so people pay attention to new energy.
Dongke Wu +3 more
core +1 more source
WAVE PREDICTIONS AT THE SITE OF A WAVE ENERGY CONVERSION ARRAY [PDF]
The SWAN spectral wave model was applied to a domain along the coast of Oregon State, USA with the purpose of establishing a better understanding of wave conditions at a location which has been proposed for the installation of an array of Wave Energy Converters (WECs).
Jeffrey A Oskamp, H Tuba Özkan-Haller
openaire +1 more source
This review highlights advances in lightweight, lead‐free polymer nanocomposites for diagnostic X‐ray shielding. By linking filler chemistry, dispersion, architecture, and photon interaction mechanisms, it establishes structure–performance relationships guiding material design.
Aklilu G. Messele +2 more
wiley +1 more source
Precipitation Simulations of the O‐Phase in Ti2AlNb Alloys Processed by Laser Powder Bed Fusion
Simulated and experimental evolution of the O‐phase volume fraction during postprocessing of a Ti‐21Al‐25Nb (at.%) alloy processed by laser powder bed fusion. With results of sensitivity to input parameters from a thorough and quantified analysis, the interfacial energy matrix/precipitate is the most relevant input parameter for the simulation of the O‐
Silvana Tumminello +7 more
wiley +1 more source
WEC Scale Model Build & Test: Fabrication and Wave Laboratory Testing of 1/10 Scale Wave Energy Conversion Device [PDF]
Neptune Wave Power, LLC (‘NWP’), worked with OWET, the Northwest National Marine Renewable Energy Center (‘NNMREC’) and Oregon State University (O.H. Hinsdale Wave Research Laboratory) to build and test a 1/10 scale model wave energy conversion (‘WEC ...
Neptune Wave Power LLC +1 more
core
Radical innovation for the wave energy sector: an investigation of the potential of direct conversion as an enabling technology [PDF]
While wave energy has been under development for over 40 years, as of 2023 it has not reached commercialisation. The wave energy sector has yet to develop a low-cost device that can demonstrate a level of reliable long-term electricity generation.
Kerr, Paul
core +1 more source

