Results 71 to 80 of about 3,714,404 (278)

Investigation on the extreme peak mooring force distribution of a point absorber wave energy converter with and without a survivability control system

open access: yes, 2023
To determine the optimal design of the wave energy converter (WEC) that can withstand extreme waveconditions, the short- and long-term extreme responses of the system need to be determined. This paper focuses on the extreme peak force distribution of the
Shahroozi, Zahra,   +5 more
core   +1 more source

Electrochemical Behavior of Flame‐Sprayed Sc‐Doped AlCoCrFeMo High‐Entropy Alloy Coatings in 3.5% Sodium Chloride Solution

open access: yesAdvanced Engineering Materials, EarlyView.
Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar   +7 more
wiley   +1 more source

Enhancement of the Through‐Thickness Electrical Conductivity of Carbon‐Fiber‐Reinforced Plastics Using Large Graphite Particles

open access: yesAdvanced Engineering Materials, EarlyView.
To enhance through‐thickness conductivity without sacrificing impregnation, large spherical graphite particles are intentionally employed in a low‐viscosity resin. Unlike finer conductive fillers, these particles remain outside the fiber bundles and accumulate in resin‐rich interlaminar regions during molding.
Keito Hosoe   +6 more
wiley   +1 more source

An Experimental Study on Wave Force and Run-Up of Wind Turbine Foundation on Breakwater Under Wave Action

open access: yesEnergies
With the development and utilization of offshore wind turbines in the field of existing breakwaters, its foundation is affected by the dual effects of waves and different structures.
Jiangnan Chen   +3 more
doaj   +1 more source

Experimental study on the wave force loads on a large-scale cylinder by multidirectional waves

open access: yesShui kexue jinzhan, 2018
Wave force is the main load on the offshore structure, accurate predictions the wave loads on structures are significant in practice engineering design.
JI Xinran   +3 more
doaj   +1 more source

Development of a Cold Wall Reactor System for the Low‐Pressure Chemical Vapor Deposition of BN on SiC Fiber Tow

open access: yesAdvanced Engineering Materials, EarlyView.
A cold wall reactor is developed to coat a SiC fiber tow with BN by low pressure chemical vapor deposition. The precursor gas is triethylamine borane mixed with ammonia. The heating process induces a temperature gradient, with the temperature decreasing from the core to the surface of the multifilament tow.
Pierre Fenetaud, Sylvain Jacques
wiley   +1 more source

Laser‐Induced Graphene from Waste Almond Shells

open access: yesAdvanced Functional Materials, EarlyView.
Almond shells, an abundant agricultural by‐product, are repurposed to create a fully bioderived almond shell/chitosan composite (ASC) degradable in soil. ASC is converted into laser‐induced graphene (LIG) by laser scribing and proposed as a substrate for transient electronics.
Yulia Steksova   +9 more
wiley   +1 more source

Achieving High ON State Current through Ferroelectric Polarization‐Dependent Interfacial Resistance Switching in Undoped Orthorhombic HfO2 Films

open access: yesAdvanced Functional Materials, EarlyView.
Ferroelectric tunnel junction devices based on epitaxial undoped ferroelectric HfO2 films demonstrate stable switching endurance of over 106 switching cycles, low write voltages of ±3 V, 16 measured resistance states, and neuromorphic capability.
Markus Hellenbrand   +13 more
wiley   +1 more source

Advances in Sustainable and Wearable Textile Based Soft Robotics

open access: yesAdvanced Functional Materials, EarlyView.
This Review examines advances in wearable textile‐based soft robotics, focusing on sustainable materials, integrated sensing, and scalable actuation. It discusses manufacturing and system integration across healthcare, assistive robotics, prosthetics, and human–machine interfaces, and highlights key challenges in circular design, including life‐cycle ...
Zahir Abbas   +6 more
wiley   +1 more source

Numerical Study of Hydrodynamic Characteristics of a Three-Dimensional Oscillating Water Column Wave-Power Device

open access: yesJournal of Marine Science and Engineering
The impact of wave-induced forces on the integrity of stationary oscillating water column (OWC) devices is essential for ensuring their structural safety. In our study, we built a three-dimensional numerical model of an OWC device using the computational
Jun-Lin Zhu   +3 more
doaj   +1 more source

Home - About - Disclaimer - Privacy