Results 181 to 190 of about 75,113 (266)

Hierarchical Multi‐Material Architectures With Gradient Design for Dynamic‐Range Flexible Tactile Sensing

open access: yesAdvanced Materials Technologies, EarlyView.
Hierarchical multi‐material TPMS lattices are engineered as flexible tactile sensors by combining soft and stiff elastomeric layers with a conformal conductive coating. The bilayer architecture delivers sensitivity at low pressures while maintaining a broad detectable range under large loads, enabling reliable pressure and vibration monitoring for ...
Reza Noroozi   +3 more
wiley   +1 more source

Skin‐Like Tri‐Modal Sensors Based on Soft Piezoelectric and Ionic Composites

open access: yesAdvanced Materials Technologies, EarlyView.
Inspired by the multimodal perception of human skin, a soft, skin‐like tri‐modal sensor is presented. The device incorporates an ionically conductive, piezoelectric, elastic composite as its active layer, enabling independent detection of temperature, static strain, and dynamic strain within a single two‐terminal architecture.
Liren Wang   +9 more
wiley   +1 more source

Flexible Pressure Sensor With Co‐Optimized Sensitivity and Linearity Based on Gradient Toroidal Microstructures

open access: yesAdvanced Materials Technologies, EarlyView.
A flexible piezoresistive pressure sensor with gradient toroidal CNT/PDMS microstructures is reported. The hierarchical geometry enables sequential electrode contact, achieving a sensitivity of 256.20 kPa−1 and linear response (R2 = 0.99) over 0–1000 kPa.
Rongmei Wang   +8 more
wiley   +1 more source

Wood‐Derived Nanocellulose‐Biocarbon Fresnel‐Zone Plate Lenses for Sub‐THz Frequency Applications

open access: yesAdvanced Materials Technologies, EarlyView.
Wood‐derived nanocellulose and lignin‐based biocarbon were combined to fabricate fully bio‐based Fresnel zone plate (FZP) lenses for sub‐terahertz frequencies. These sustainable FZP lenses exhibit low dielectric loss and high directivity, achieving performance comparable to that of metallic references, and remain functional under environmental stress ...
Riikka Haataja   +9 more
wiley   +1 more source

3D‐Printed Dual‐Doped Ag2Se‐Based Thermoelectric Films With Enhanced Thermal Stability

open access: yesAdvanced Materials Technologies, EarlyView.
Sb–Se dual doping enhances the thermal stability of Ag2Se‐based thermoelectric systems. The compositionally tuned nano‐ink is printed into flexible films by direct ink writing (DIW), retaining improved thermoelectric properties after annealing up to 400°C.
Ahasun Habib Hridoy   +8 more
wiley   +1 more source

Ultra‐White Elastomeric Coatings for Daytime Radiative Cooling

open access: yesAdvanced Materials Technologies, EarlyView.
Passive daytime radiative cooling meets elasticity in a new class of ultra‐white silicone coatings. Combining high solar reflectance with strong sky‐window emission, they hold surfaces below ambient temperature under full sunlight while remaining flexible and stretchable. This combination of cooling performance and mechanical flexibility enables energy‐
Abdulrahman Aljwirah   +5 more
wiley   +1 more source

Analysis of serological markers and synovial fluid cytology in aseptic revision total knee arthroplasty. [PDF]

open access: yesArch Orthop Trauma Surg
Khury F   +6 more
europepmc   +1 more source

Home - About - Disclaimer - Privacy