Results 81 to 90 of about 133,673 (307)
Advanced Engineering Materials, EarlyView.Geometry‐driven thermal behavior in wire‐arc additive manufacturing (WAAM) influences microstructural evolution during nonequilibrium solidification of a chemically complex Fe–Cr–Nb–W–Mo–C nanocomposite system. By comparing different deposits configurations, distinct entropy–cooling rate correlations, segregation, and carbide evolution are revealed ...
Blanca Palacios +5 more
wiley +1 more source
The next generation textile antennas based on substrate integrated waveguide technology [PDF]
, 2014 Textile antennas for body-worn applications have some very specific requirements and needs. From an electrical engineer's point of view, good radiation characteristics and impedance matching to the active electronics are important.
Agneessens, Sam +4 more
core +2 more sources
Advanced Engineering Materials, EarlyView.Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi +2 more
wiley +1 more source
Flexible and stretchable power sources for wearable electronics. [PDF]
, 2017 Flexible and stretchable power sources represent a key technology for the realization of wearable electronics. Developing flexible and stretchable batteries with mechanical endurance that is on par with commercial standards and offer compliance while ...
Arias, Ana Claudia +8 more
core +2 more sources
Advanced Engineering Materials, EarlyView.The presented study focuses on the fracture behaviour of carbon‐bonded magnesia MgO–C refractories, where environmentally friendly fructose, collagen and lignin serve as temporary binding agents. The partial substitution of the source material with recycled MgO–C reduces the fracture resistance, which can be counteracted by the additional introduction ...
Marc Neumann +6 more
wiley +1 more source
Perovskite Photodiode for Wearable Electronics [PDF]
, 2018 Photodetectors are sensing devices that have been used for a broad range electromagnetic wave sensing applications. We are currently investigating the use of photovoltaic cells for implantable and wearable applications [1] [2].
Ghannam, Rami +2 more
core
Influence of an Oxygen‐Free Atmosphere on Diamond‐Single‐Grain Scratching of Ti–6Al–4V
Advanced Engineering Materials, EarlyView.Single‐grain scratching of Ti–6Al–4V is investigated under controlled, oxygen‐free, and ambient atmospheres using a novel experimental setup with in situ high‐speed imaging. The approach enables direct observation of chip formation and adhesion under suppressed oxidation.
Berend Denkena +2 more
wiley +1 more source
Wearable Electronic Materials: Types, Properties and Applications
, 2023 Wearable technology is currently at the cutting edge of both industry and academic research, and a number of wearable products are now on the market. Inorganic nanomembranes can be transferred to almost any substrate and can be shaped (they are elastic, printable, and flexible).
openaire +1 more source
Advanced Engineering Materials, EarlyView.The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert +6 more
wiley +1 more source
Wearable Capacitive-based Wrist-worn Gesture Sensing System [PDF]
, 2017 Gesture control plays an increasingly significant role in modern human-machine interactions. This paper presents an innovative method of gesture recognition using flexible capacitive pressure sensor attached on user’s wrist towards computer vision and ...
Dahiya, Ravinder +2 more
core +1 more source