Results 31 to 40 of about 47,462 (292)
Metalurgija, 2020 Based on the welding numerical simulation software Visual-environment, this paper calculates and analyzes the residual stress field for the double pass welding of Q345 stacked plates. The paper mainly studies the influence of different welding directions
B. Xu, H. Fu, Q. H. Xiao, S. Li, T. Kang
doaj
Metals, 2017 The reliability of welded structure can be evaluated through welding residual stress analysis and fatigue strength assessment. In this study, welding residual stresses of multi-pass dissimilar material welded joint between alloy 617 and 12Cr steel were ...
Hafiz Waqar Ahmad +3 more
doaj +1 more source
Materials Research Express, 2022 The quantification of the residual stress and distortion in the thick-plate weld joint of AF1410 steel has great significance, which is the basis for the safety and process design of the component.
Kaiyuan Zhang, Wenchao Dong, Shanping Lu
doaj +1 more source
Numerical modeling of the electron beam welding and its experimental validation [PDF]
, 2016 Electron Beam Welding (EBW) is a highly efficient and precise welding method increasingly used within the manufacturing chain and of growing importance in different industrial environments such as the aeronautical and aerospace sectors.
Agelet de Saracibar Bosch, Carlos +5 more
core +4 more sources
Duplex Stainless Steel Laser‐Surface Textured: Stability in Brine Solution
Advanced Engineering Materials, EarlyView.Controlled laser‐surface treatment (LST) of duplex DSS2205 steel is performed to increase its stability in brine solution under cyclic electrochemical assays. The superior protection with respect to flat and smooth panels is attributed to the presence of FeCr2O4 as the main protective oxide layer in the LST surface, after corrosion tests. The stability
Mohammad Rezayat +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study investigates laser metal deposition of aluminum alloys EN AW‐7075 and EN AW‐5083, using powder blending to compensate zinc and magnesium evaporation. In situ alloying and ex situ alloying with ZnAl12 and AZ91 preserve near‐standard compositions and improve mechanical properties.
Finn Bendixen +3 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
Q345C weld deformation analysis of butt joints
Metalurgija, 2023 Q345C steel is welded under two different pre-welding heating methods of traditional flame heating and ceramic sheet heating. The finite element analysis of the butt joint weldment by ABAQUS software is used to summarize the law of welding deformation ...
Y. Z. Zhong +5 more
doaj
Experimental Research of Welding Residual Stress of Butt Welded Joint of Thick Steel Plate
Metals, 2023 The thickness of steel plates used in the structure has gradually increased to meet the load-bearing capacity requirements of long-span steel bridges.
Wenliang Lu +4 more
doaj +1 more source
The effect of vibratory stress on the welding microstructure and residual stress distribution [PDF]
, 2001 Previous studies have suggested that weld microstructure may be modified by the presence of static stresses. In this investigation, vibratory stress was applied to mild steel specimens while they were being welded to observe its effect on the residual ...
Munsi, A.S.M.Y. +2 more
core