Results 31 to 40 of about 22,908 (317)
Electrical engineering & Electromechanics, 2023 Introduction. Wind energy conversion system is getting a lot of attention since, they are provide several advantages, such as cost competitive, environmentally clean, and safe renewable power source as compared with the fossil fuel and nuclear power ...
A. Boukadoum, A. Bouguerne, T. Bahi
doaj +1 more source
Towards greener horizontal-axis wind turbines: Analysis of carbon emissions, energy and costs at the early design stage [PDF]
, 2015 This paper describes the development of a quantitative analysis system as a platform for rapidly estimate energy, costs and carbon emission to facilitate the comparison of different wind turbine concept designs.
Aso, Raymond, Cheung, Wai Ming
core +1 more source
IEEE Access, 2018 This paper presents a radial basis function network (RBFN) controller-based three-phase boost-type Vienna rectifier for a grid-tied wind energy conversion system.
Damodhar Reddy, Sudha Ramasamy
doaj +1 more source
Integrated optimal design and sensitivity analysis of a stand alone wind turbine system with storage for rural electrification [PDF]
, 2013 In this paper, the authors investigate a robust Integrated Optimal Design (IOD) devoted to a passive wind turbine system with electrochemical storage bank: this stand alone system is dedicated to rural electrification.
Jaafar, Amine +4 more
core +1 more source
Control and Supervision of Wind Energy Conversion Systems [PDF]
, 2016 This paper is about a PhD thesis and includes the study and analysis of the performance of an onshore wind energy conversion system. First, mathematical models of a variable speed wind turbine with pitch control are studied, followed by the study of different controller types such as integer-order controllers, fractional-order controllers, fuzzy logic ...
Carla Viveiros +3 more
openaire +2 more sources
Integrated Optimal Design of a Passive Wind Turbine System: An Experimental Validation [PDF]
, 2010 This work presents design and experimentation of a full passive wind turbine system without active electronic part(power and control). The efficiency of such device can be obtained only if the system design parameters are mutually adapted through an ...
Sareni, Bruno +4 more
core +1 more source
Wind energy conversion systems
, 2020 The production of electricity from wind energy presents an increased growth and sustained since 1985. Currently, there are wind generators located throughout the world whose power already reaches values exceeding 250 GW. The main technologies used in electromechanical conversion of wind energy into electric energy are based primarily on three types of ...
openaire +3 more sources
Ultra high wind energy penetration in an isolated market
, 2008 Paper presented at the IEEE Power and Energy Society 2008 PES General Meeting - Conversion and Delivery of Electrical Energy in the 21st Century, 20-24 July 2008, Pittsburgh, PA, USAThis paper addresses the market design implications of implementing ...
Aoife Crowe +12 more
core +1 more source
International Journal of Electrical Power & Energy SystemsIn wind energy conversion power system, some sensor and actuator fall into abnormal condition which may lead to lower wind energy utilization rate and poor system performance or even system collapse.
Zhihong Huo, Chang Xu
doaj +1 more source
A Maximum Power Point Tracking Control Method Based on Rotor Speed PDF Shape for Wind Turbines
Applied Sciences, 2022 Maximum power point tracking (MPPT) is the key to improve the conversion efficiency of wind energy. Concerning the current research on the MPPT control, based on the accurate tracking of rotor speed probability density function (PDF) shape for wind ...
Xinge Zhang +3 more
doaj +1 more source