Results 11 to 20 of about 3,958,381 (299)
Wind Tunnel Tests for Wind Pressure Distribution on Gable Roof Buildings [PDF]
Gable roof buildings are widely used in industrial buildings. Based on wind tunnel tests with rigid models, wind pressure distributions on gable roof buildings with different aspect ratios were measured simultaneously.
Xiao-kun Jing, Yuan-qi Li
doaj +2 more sources
A Wind Tunnel Simulation Facility for On-Road Transients [PDF]
This paper outlines the creation of a facility for simulating on-road transients in a model scale, ¾ open jet, wind tunnel. Aerodynamic transients experienced on-road can be important in relation to a number of attributes including vehicle handling ...
Sims-Williams, D.B. +5 more
core +1 more source
Wind loads analysis at the anchorages of the Talavera de la Reina cable stayed bridge [PDF]
This paper describes wind tunnel tests performed on wind tunnel models of the Talavera de la Reina cable stayed bridge. The work describes the aeroelastic model construction and it is focused on the evaluation and analysis of the mean and peak wind loads
Squicciarini, G. +9 more
core +1 more source
majaczech/wind-tunnel: 3D Printed Wind Tunnel
3D Printed Wind Tunnel This is 3D printed wind tunnel with Arduino-based unit. This source describes Open Hardware and is licensed under the CERN-OHL-S v2 Experience with Arduino platform is required and supervision from a qualified electric engineering
majaczech
core +1 more source
Design of a low-noise aeroacoustic wind tunnel facility at Brunel University [PDF]
This paper represents the design principle of a quiet, low turbulence and moderately high speed aeroacoustic wind tunnel which was recently commissioned at Brunel University.
Kim, JH +5 more
core +1 more source
Research and Perspectives on Fire-Fighting Systems in Tunnels under Strong Piston Wind Action
Guided by the technical requirements for tunnel fire safety, an overview of tunnel piston wind, combustion models, and full-size and small tunnel fire tests is presented.
Xiaoyi Zhao, Zhile Shu, Xiangjun Pei
doaj +1 more source
This thesis is divided into, two distinct parts. Part I describes the design and development of an intermittent cryogenic wind-tunnel, in which the cold conditions are generated by the expansion of high pressure gas.
Mohan, S. R.
core +3 more sources
Design and performance of an open jet wind tunnel for aero-acoustic measurement [PDF]
This paper presents the design and performance of an open jet, blow down wind tunnel that was newly commissioned in the anechoic chamber at the ISVR, University of Southampton, UK. This wind tunnel is intended for the measurement of airfoil trailing edge
Chong, T.P. +5 more
core +1 more source
Influence of Ultrasonic Wind Sensor Position on Measurement Accuracy under Full-Scale Conditions
A system designed for making field measurements of wind action on engineering structures is described. The system is composed of sonic anemometers, differential pressure sensors, a barometer, and a thermohygrometer.
Tomasz Lipecki +2 more
doaj +1 more source
Wind Tunnel Testing of ONERA-M, AGARD-B and HB-2 Standard Models at Off-Design Conditions
Published results for standard wind tunnel models at non-standard test conditions are quite rare and/or may not be available. It has been found that those results are a useful aid in preparations for a number of wind tunnel tests in the Military ...
Dijana Damljanović +4 more
doaj +1 more source

