Results 161 to 170 of about 5,202 (288)
steel research international, EarlyView.Hydrochar‐mill‐scale briquettes with varying C/O molar ratios (0.07–0.90) have been tested at 1650 °C to evaluate their slag foaming performance for electric arc furnace application. All seven briquette recipes developed succeed in promoting slag foaming.
Yu‐Chiao Lu +3 more
wiley +1 more source
steel research international, EarlyView.The high‐strain‐rate behavior of resistance spot‐welded DP800–DP1000 joints is investigated. Results show that microstructural gradients across BM–HAZ–FZ govern hardness, strain rate sensitivity, and failure modes. While strength increases with strain rate, energy absorption is controlled by ductility, with DP800–DP800 joints showing superior ...
Pankaj Shrivastava, Velaphi Msomi
wiley +1 more source
Development of Wire Arc Additive Manufacturing setup
International Journal of Innovations in Engineering and Science, 2021 Sachin A. Mastud, Sushrut M. Kulkarni
openaire +1 more source
Assessing the Environmental and Economic Impact of Wire-Arc Additive Manufacturing [PDF]
29Additive Manufacturing (AM) has continuously been integrated in the modern production landscape and complements traditional manufacturing processes by allowing the creation of complex three-dimensional objects through layer-by-layer material deposition.
Belghith, Khouloud +4 more
core
Early use of the reinforced concrete in the architecture of the Historicism in Austria–Hungary
Structural Concrete, EarlyView.Abstract The study examines the early incorporation of reinforced concrete in the architecture of Historicism in Austria–Hungary. Spanning the late 19th to early 20th centuries, the research illuminates the period's stylistic pluralism and the transformative impact of reinforced concrete.
Éva Lovra, Zoltán Bereczki
wiley +1 more source
Structural Concrete, EarlyView.Abstract Steel fiber reinforced concrete (SFRC) enhances the flexural capacity of flat slabs and, due to its effectiveness in statically redundant bi‐dimensional elements, represents a viable alternative to conventional reinforcement. Although numerous studies have investigated the flexural behavior of SFRC slabs with and without bonded reinforcement ...
Chiara Gaddi +2 more
wiley +1 more source
Nonthermal plasma approaches for combating implant‐associated infections: A compendious review
VIEW, EarlyView.Implant‐associated infections pose serious clinical challenges. Non‐thermal plasma (NTP) modifications overcome this bottleneck in distinct ways relative to traditional sterilization methods. Gas‐phase plasmas generate highly energetic species, UV radiation and reactive oxygen/nitrogen species (RONS), which alter the implant surface properties.
A. M. Trimukhe +8 more
wiley +1 more source
On Line CAM for Wire Arc Additive Manufacturing [PDF]
Proceedings of CAD'18, 2018 Radel Simon +3 more
openaire +1 more source
High Voltage, EarlyView.ABSTRACT Currently, limited research exists on the structural response and protection methods of the converter transformer tank for ± 800 kV ultra‐high voltage direct current transmission project to high energy arc faults. This research investigates the dynamic response and the vulnerable areas of the ultra‐high voltage converter transformer under the ...
Ke Wang +5 more
wiley +1 more source
High Voltage, EarlyView.ABSTRACT To effectively suppress transient overvoltages in HVDC systems, the design and experimental validation of a multi‐module series controllable arrester are presented. The voltage‐limiting performance, series voltage equalisation capability, and robustness under fault conditions in high‐voltage scenarios require further research.
Tai Yang +4 more
wiley +1 more source