Results 131 to 140 of about 5,819,479 (316)
A study of X-ray binaries in the local universe
, 2013 In this thesis I present the research carried out on X-ray binaries in the Local Universe. These X-ray binaries are found in a wide variety of environments and display an array of interesting characteristics.
Joseph, Tana
core
Laser Powder Bed Fusion of Alumina: Effects of Scanning Strategies on External and Internal Defects
Advanced Engineering Materials, EarlyView.This study investigates how scanning strategies affect pure alumina in laser powder bed fusion. Linear 45° scanning yields uniform surfaces but high porosity, while the island‐concentric strategy provides higher density with through‐holes favorable for infiltration. Findings highlight pathways toward optimizing defect‐free alumina parts.
Mohamed Abdelmoula +7 more
wiley +1 more source
Optically and x-ray selected galaxy groups at intermediate redshift [PDF]
, 2012 In this thesis I present the properties of two samples of galaxy groups containing 39 high quality X-ray selected systems and 38 optically (spectroscopically) selected systems in coincident spatial regions at 0 ...
Connelly, Jennifer L.
core
, 2014 A new modular X-ray-transparent experimental cell enables tomographic investigations of fluid rock interaction under natural reservoir conditions (confining pressure up to 20 MPa, pore fluid pressure up to 15 MPa, temperature ranging from 296 to 473 K ...
Zhu, Wenlu +6 more
core +1 more source
Advanced Engineering Materials, EarlyView.Powder metal processing provides scalable advantages in nanoporous (np) metal development. Mechanical alloying is used to produce unique precursors for hybrid nanopore formation by oxide reduction and dealloying. As demonstrated in np Ag, this approach improves process efficiency while promoting smaller ligaments and larger pores, both of which are ...
Mark A. Atwater, Oliver A. Fowler
wiley +1 more source
Development of an x-ray excited optical luminescence microscope (XEOM) [PDF]
X-ray excited optical luminescence (XEOL) refers to the trans-visible emission produced as a consequence of X-ray bombardment and provides an alternative detection method for X-ray absorption spectroscopy (XAS). Whereas XAS measured by conventional means
Hand, M. (Matthew)
core
Advanced Engineering Materials, EarlyView.This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo +3 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Very high energy gamma ray astronomy and non pulsating low mass x-ray binaries [PDF]
, 1991 This thesis is concerned with non pulsating Low Mass X-Ray Binaries as Very High Energy γ-ray sources, in particular Scorpius X-1; the brightest of these objects in X-rays, and the most likely to be detectable at energies above 250 GeV.
Carraminana, Alberto, Carraminana, A
core
The X-ray crystal structures of primary aryl substituted selenoamides
, 2009 The authors are grateful to the University of St Andrews and the Engineering and Physical Science Research Council (EPSRC, U.K.) for financial support.The X-ray structures of 12 primary selenoamides are reported.
Guo-Xiong Hua +8 more
core +1 more source