Results 161 to 170 of about 1,113,780 (339)
The Interpretation of X-ray Diffraction Photographsby N. F. M. Henry, H. Lipson and W. A. Wooster [PDF]
, 1952 C. H. MacGillavry
openalex +1 more source
Development of SiC Nanocomposites Using Direct Ink Writing Process
Advanced Engineering Materials, EarlyView.Herein, feedstock inks containing polycarbosilane and various concentrations of SiC nanoparticles (SiCnp) are investigated for fabricating ceramic matrix composites using a DIW 3D printing process. Characterization results from physical measurement, microstructure analysis, and thermal and flexural testing suggested that high‐performance CMC samples ...
Jinchen Han +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Sludge phases with brittle fracture behavior form in AlMgSi alloys with high concentrations of alloying elements and negatively influence their ductility. The phase type mainly depends on the Si content and the concentration of minor alloying elements like Fe, Mn, Cr, and Mo strongly influences the number of sludge particles. The need for sustainable
Dominik Steinacker +3 more
wiley +1 more source
The diffraction of X-rays and elektrons by amorphous solids, liquids and gases [PDF]
, 1935 F. Regler
openalex +1 more source
Improved Strength and Corrosion Resistance of Ti–50Zr Alloy Through Heat Treatment
Advanced Engineering Materials, EarlyView.This work systematically analyzes the effects of heat treatment on mechanical properties and corrosion behavior of Ti‐50Zr alloy produced via vacuum arc melting. Microstructure transforms from coarse lamellar α phase in as‐cast condition to fine and uniformly distributes acicular α′ phase in heat‐treatment state.
Yuhua Li +7 more
wiley +1 more source
Effect of Particle-Size on the Quantitative Determination of Quartz by X-ray Diffraction [PDF]
, 1955 Robert L. Gordon, G. W. Harris
openalex +1 more source
Advanced Functional Materials, EarlyView.Graded refractive index (GRI) structures are prepared from the layer‐by‐layer spray coating of the mesoporous SiO2 nanoparticles, showing high solar transparency and thermal emissivity. Under outdoor conditions, after 50 days, the GRI‐coated photovoltaics show on average 6.65 ± 1.48 °C lower than that of the non‐coated references, maintaining 80.9 ± 8 ...
Heesuk Jung +14 more
wiley +1 more source
Advanced Functional Materials, Volume 35, Issue 12, March 18, 2025.The formate pseudo‐halide anion is strategically introduced at the buried interface to stabilize the intermediate phases formed during perovskite crystallization. The controlled crystallization enhances crystallinity and alleviates tensile strain, eliminating residual PbI2 near the buried interface.
Jongdeuk Seo +12 more
wiley +1 more source