Regional similarities in the distributions of well yield from crystalline rocks in Fennoscandia [PDF]
, 2010 Well yields from Precambrian and Palaeozoic bedrock in Norway, Sweden and Finland exhibit very similar and approximately log-normal distributions: all three data sets exhibit a median yield of 600–700 L hr-1, despite the differences in climate and ...
Gustafson, G. +4 more
core +9 more sources
Nanomaterials, 2021 The plastic flow behaviors of FCC polycrystalline aluminum after pre-cyclic tension-compression deformation are mainly investigated in tension–torsion stress space by the physically based crystal plasticity model introducing a back-stress.
Damin Lu, Keshi Zhang, Guijuan Hu
doaj +1 more source
Nihon Kikai Gakkai ronbunshu, 2016 This study focused on ruptures due to bending deformation of steel pipe that is operated with a high design factor. The design factor refers to the ratio of the hoop stress from internal pressure to the yield strength of pipe material.
Masaki MITSUYA
doaj +1 more source
Low secondary electron yield engineered surface for electron cloud mitigation [PDF]
, 2014 Secondary electron yield (SEY or δ) limits the performance of a number of devices. Particularly, in high-energy charged particle accelerators, the beam-induced electron multipacting is one of the main sources of electron cloud (e-cloud) build up on the ...
Oleg B. Malyshev +14 more
core +1 more source
Surface construction for orthrotropic perfectly elastic-plastic Murnaghan material
Весці Нацыянальнай акадэміі навук Беларусі: Серыя фізіка-тэхнічных навук, 2021 The problem of constructing a yield surface is described. The magnitude of the stress velocity potential is explained graphically. The parameters of an elastic-plastic process are introduced: a modified R.
O. L. Shved
doaj +1 more source
Surface profile prediction and analysis applied to turning process [PDF]
, 2008 An approach for the prediction of surface profile in turning process using Radial Basis Function (RBF) neural networks is presented. The input parameters of the RBF networks are cutting speed, depth of cut and feed rate.
LU, Chen, COSTES, Jean-Philippe
core +1 more source
Brewster-angle measurements of sea-surface reflectance using a high resolution spectroradiometer [PDF]
, 2002 This paper describes the design, construction and testing of a ship-borne spectroradiometer based on an imaging spectrograph and cooled CCD array with a wavelength range of 350-800 nm and 4 nm spectral sampling.
Woods, Peter +2 more
core +4 more sources
A Graphical Approach to Yield and Boundary Surfaces of Selected Hypoplastic Constitutive Equations
Archives of Civil Engineering, 2011 W artykule przedstawiono sposób wyznaczania powierzchni płyniecia oraz powierzchni granicznej dla przykładowych równan konstytutywnych w ramach teorii hypoplastycznosci zaproponowanych przez Wu, Gudehus’a oraz Bauer’a.
Sikora Z., Ciesla P.
doaj +1 more source
Surface roughness prediction in milling based on tool displacements [PDF]
, 2011 In this paper, an experimental device using non-contact displacement sensors for the investigation of milling tool behaviour is presented. It enables the recording of high frequency tool vibrations during milling operations.
MOREAU, Vincent +3 more
core +1 more source
Assessment of hydrology, sediment and particulate organic carbon yield in a large agricultural catchment using the SWAT model [PDF]
, 2011 The Soil and Water Assessment Tool (SWAT, 2005) was used to simulate discharge and sediment transport at daily time steps within the intensively farmed Save catchment in south-west France (1110 km2).
Simeoni-Sauvage, Sabine +6 more
core +1 more source