Results 41 to 50 of about 70,306 (261)
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Agro-materials : a bibliographic review [PDF]
, 2002 Facing the problems of plastic recycling and fossil resources exhaustion, the use of biomass to conceive new materials appears like a reasonable solution.
Rouilly, Antoine, Rigal, Luc
core +1 more source
Effect of High-Temperature Heat Treatment on the Acoustic-Vibration Performance of Picea jezoensis
BioResources, 2016 The crystallinity and acoustic-vibration parameters of Picea jezoensis, including specific Young’s modulus (E/ρ),coefficient of sound-radiation resistance (R), sound resistance (ω), and the ratio of Young’s modulus to the dynamic stiffness modulus (E/G),
Lingjing Zhu, Yixing Liu, Zhenbo Liu
doaj +1 more source
Study on Rock Mechanics Parameters of Chang 7 Shale in Longdong Area in Ordos Basin [PDF]
E3S Web of Conferences, 2019 Rock samples from X-1 and X-2 well of Chang 7 shale in Longdong area in Ordos Basin are studied through triaxial compression test and acoustic wave test in order to obtain accurate data about the mechanical characteristics of the stratum and fracturing ...
Li Zhenhua +3 more
doaj +1 more source
Micromachines, 2021 3C-SiC is an emerging material for MEMS systems thanks to its outstanding mechanical properties (high Young’s modulus and low density) that allow the device to be operated for a given geometry at higher frequency.
Sergio Sapienza +6 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
Temperature-Dependent Young’s Modulus of TaC- and TiC-Strengthened Co-Re-Based Alloys
MetalsThe knowledge of Young’s modulus is important for a quantitative assessment of strengthening contributions in CoRe alloys, such as strengthening by carbides.
Torben Fiedler +3 more
doaj +1 more source
Additive Gaussian Process Regression for Predictive Design of High‐Performance, Printable Silicones
Advanced Engineering Materials, EarlyView.A chemistry‐aware design framework for tuning printable polydimethylsiloxane (PDMS) for vat photopolymerization (VPP) is developed using additive Gaussian process (GP) modeling. Polymer network mechanics informs variable groupings, feasible formulation constraints, and interaction variables.
Roxana Carbonell +3 more
wiley +1 more source
Archives of Metallurgy and Materials, 2015 The effect of annealing on dynamic Young’s modulus, E, of ultrafine-grained (UFG) copper obtained by combined severe plastic deformation (SPD) is investigated.
Pal-Val P. +4 more
doaj +1 more source
Materials & Design, 2022 A high-priority target in the design of new metallic materials for load-bearing implant applications is the reduction of Young’s modulus approximating that of cortical bone in the predominant loading direction.
Stephan Schönecker +6 more
doaj +1 more source