Results 1 to 10 of about 3,097 (162)

Using Taguchi Design to Compare the Corrosion Behavior of Commercial Pure Ti Alloys Coated by Dip and Electrophoretic Deposition with YSZ [PDF]

open access: yesEngineering and Technology Journal, 2023
This study makes experimental evaluations of the corrosion and tip tests of  CP-Ti joint (commercial pure Ti) implant alloys coated with YSZ nanoceramic. A Taguchi design of experiments (DOE) strategy was used to create a thin adhesive covering utilizing
Marwan Hussein   +2 more
doaj   +1 more source

Short-Term Strong Cathodic Polarization of Ni/YSZ and Pt/YSZ [PDF]

open access: yesJournal of The Electrochemical Society, 2021
The initial stages of YSZ reduction and formation of intermetallic phases at Ni∣YSZ interfaces on strongly cathodically polarized electrodes were studied by a number of potential sweep and impedance techniques. The measurements were carried out in the potential range −1.0 V to −3.0 V vs E°(O2) in H2/H2O at 650 and 750 °C.
Karin Vels Hansen   +3 more
openaire   +2 more sources

ANALISIS PENGARUH KONDUKTIVITAS IONIK MATERIAL ELEKTROLIT PADA KINERJA SOLID OXIDE FUEL CELL

open access: yesRekayasa Mesin, 2022
SOFC electrolytes are known for their ohmic resistance aspect, which is dependent on temperature. Using COMSOL Multiphysics numerical simulation, analysis of SOFC power performance with yttria-stabilized zirconia (YSZ) and lithium sodium carbonate ...
Fahrizal Perdana Fahmul   +1 more
doaj   +1 more source

Catalytic methane combustion at low temperatures over YSZ-supported metal oxides: Evidence for lattice oxygen participation via the use of C18O2

open access: yesCatalysis Communications, 2023
Catalytic methane combustion was carried out over YSZ, Pd/YSZ and Rh/YSZ between 200 and 700 °C. Despite similar light-off curves for Pd/YSZ and Rh/YSZ between 200 and 450 °C, isotopic exchange experiments using CD4 and 18O2 revealed different behaviour ...
Alexandre Nau   +6 more
doaj   +1 more source

Comparison of the Degradation of the Polarisation Resistance of Symmetrical LSM-YSZ cells, with Anode Supported Ni-YSZ/YSZ/LSM-YSZ SOFCs [PDF]

open access: yesECS Transactions, 2009
Impedance spectra of a symmetrical cell with SOFC cathodes (LSM-YSZ/YSZ/LSM-YSZ) and an anode supported planar SOFC (Ni-YSZ/YSZ/LSM-YSZ) were collected at OCV at 650{degree sign}C in air (cathode) and humidified (4%) hydrogen (anode), over 155 hours. The impedance was affected by degradation over time in the same frequency range for both cells (~10 Hz),
Torres da Silva, Iris Maura   +3 more
openaire   +3 more sources

Microstructure and Properties of YSZ Coatings Prepared by Plasma Spray Physical Vapor Deposition for Biomedical Application [PDF]

open access: yesArchives of Metallurgy and Materials, 2019
This paper presents the study of microstructure and properties of 8 mol% yttrium stabilized zirconia coating fabricated by Plasma Spray Physical Vapor Deposition technique on commercial pure titanium.
J. Barczyk   +6 more
doaj   +1 more source

Thermophysical and mechanical properties of cubic, tetragonal and monoclinic ZrO2

open access: yesJournal of Materials Research and Technology, 2023
Yttrium-stabilized zirconia (YSZ) materials are routinely used as thermal barrier coatings (TBCs). The phase composition and microstructure of YSZ materials significantly influence their properties.
Xuemei Song   +7 more
doaj   +1 more source

Nanosecond laser irradiation of Yttria stabilized Zirconia: Pulsed laser ablation and surface treatment

open access: yesHybrid Advances, 2023
Nanosecond pulsed laser irradiation resulting in material ablation and surface micro structuring of Yttria Stabilized Zirconia (YSZ) targets, has been investigated.
Sucharita Sinha
doaj   +1 more source

Preparation of NiCr/YSZ two-layered burn-resistant coating on γ-TiAl alloys based on plasma surface metallurgy and ion plating methods [PDF]

open access: yesJournal of Mining and Metallurgy. Section B: Metallurgy, 2021
The NiCr/YSZ coating was fabricated on γ-TiAl alloy by double glow plasma surface metallurgy technology and multi-arc ion plating technology. The microstructure, microhardness, bonding strength, and burn resistance of NiCr/YSZ coating were studied in ...
Wei D.-B.   +5 more
doaj   +1 more source

Structural and Electrical Properties of the YSZ/STO/YSZ Heterostructure [PDF]

open access: yesJournal of Nanomaterials, 2014
The heterostructure thin films of yttria‐stabilized zirconia (YSZ)/strontium titanate (STO)/YSZ with various thicknesses were deposited on MgO single crystal substrate by pulsed laser deposition (PLD) method. The structural and electrical properties of the YSZ/STO/YSZ heterostructure were studied through X‐ray diffraction (XRD) and electrical ...
Yue Fan   +8 more
openaire   +1 more source

Home - About - Disclaimer - Privacy