Results 121 to 130 of about 2,723 (152)

EXAFS Study of Yttria‐Stabilized Zirconia

Journal of the American Ceramic Society, 1986
The local structural environments of Y 3+ and Zr 4+ in 18 wt% Y 2 O 3 ‐stabilized zirconia were studied using extended X‐ray absorption fine structure spectroscopy over the ...
C. R. A. CATLOW, A. V. CHADWICK, G. N. GREAVES, L. M. MORONEY   +3 more
openaire   +1 more source

Uniform precipitation of Yttria-Stabilized zirconia

Refractories, 1995
An experiment on precipitation of zirconia by urea, urotropin, and ammonium hydroxide precipitants is described. The morphological and phase composition of the precipitated powders are investigated. It is shown that a buffer has a positive effect on reducing the agglomeration.
L. I. Podzorova, A. A. Il'icheva, N. A. Mikhailina, V. Ya. Shevchenko, V. B. Lazarev, A. D. Izotov   +5 more
openaire   +1 more source

Conduction mechanism in yttria stabilized zirconia

Physics Letters A, 1967
Abstract Analysis of potential distribution curves in 10 Y 2 O 3 : 90 ZrO 2 at 1380°C has shown an electronic hole contribution to the conductivity to have an oxygen partial pressure dependence of p O 2 . This is postulated to arise from the reaction 1 2 O 2 ( gas ) + □ O 2 → O 2- + 2 h .
R.E.W. Casselton, J.C. Scott
openaire   +1 more source

Preparation of nanocrystalline yttria-stabilized zirconia

Journal of Materials Research, 1995
Nanocrystalline powder with an average crystallite size of 8–12 nm, which was produced by a combustion synthesis process, was used to prepare dense, nanocrystalline articles. Green compacts of high green density were prepared by dry pressing and densified by a fast-firing process.
K.R. Venkatachari, Dai Huang, Steven P. Ostrander, Walter A. Schulze, Gregory C. Stangle   +4 more
openaire   +1 more source

The Defect Structure of Yttria Stabilized Zirconia

MRS Proceedings, 1985
AbstractWe present results of EXAFS and computer simulation studies of the defect structure of yttria-stabilised zirconia. The results are analysed in terms of dopant-vacancy association models for this phase.
C.R.A. Catlow, A.V. Chadwick, A.N. Cormack, G.N. Greaves, M. Leslie, L.M. Moroney   +5 more
openaire   +1 more source

Thermal Expansion of Yttria‐Stabilized Zirconia

Journal of the American Ceramic Society, 1964
The thermal expansion of yttria-stabilized zirconia was measured in air and in a high-oxygen atmosphere. Room temperature-to-1000 deg C expansion measurements were made in an automatic recording dilatometer. Measurements above 1000 deg C were made in an oxide induction furnace and the change in length of the specimen was measured with telemicroscopes ...
T. H. NIELSEN, M. H. LEIPOLD
openaire   +1 more source

Ultrasonic attenuation in yttria-stabilized zirconia

Physica B: Condensed Matter, 1999
Abstract The acoustic attenuation at 10 MHz in yttria-stabilized zirconia (ZrO2(Y)) was measured at temperatures between 300 and 600 K. The attenuation curve showed a relaxation peak, from which the activation energy was estimated to be 0.7±0.07 eV , in good agreement with the value obtained from dielectric constant of 0.66±0.07 eV ...
Kenta Kirimoto, Kohji Nobugai, Tatsuro Miyasato   +2 more
openaire   +1 more source

Layered structures of yttria-stabilized zirconia sandwiched between platinum/ yttria-stabilized zirconia composites

Journal of Applied Physics, 2001
Layered structures of cubic yttria-stabilized zirconia (YSZ) sandwiched between two layers of platinum/YSZ composites with the platinum concentration varying between 20 and 55 vol % were prepared. Large double-layer capacitances were obtained due to the presence of large three-dimensional electrode surface areas in the composite layers. The layers were
Hendriks, M.G.H.M., Heijman, M.J.G.W., van Zyl, W.E., ten Elshof, J.E.   +3 more
openaire   +1 more source

Continuous yttria‐stabilized zirconia fibers

Advanced Materials, 1996
Polycrystalline oxide fibers have not yet been exploited to their full potential, perhaps because of difficulties with processability. In the successful new route for the production of continuous yttria‐stabilized zirconia fibers detailed here, ZrO2 particles sols are used as oxide‐forming components.
Bernd Clauss, Andrea Grüb, Wilhelm Oppermann   +2 more
openaire   +1 more source

Electrostatic dispersion of yttria-stabilized zirconia

Powder Technology, 1987
Abstract These results merely indicate that the isoelectric point for this powder is substantially different than that commonly accepted for ‘stabilized zirconia’. It is recommended that this difference be taken into account in designing process systems for the material.
openaire   +1 more source