PWM zero-voltage switching boost-derived converters with output isolation
, 1996 In this paper, the basic operations and steady-state analysis for three modified boost-derived converter topologies will be presented. Unlike the conventional boost topology, these converters provide electrical isolation and zero-voltage switching, while
Caliskan, Vahe +2 more
core +2 more sources
Implementation of Single Phase Soft Switched PFC Converter for Plug-in-Hybrid Electric Vehicles
Energies, 2015 This paper presents a new soft switching boost converter with a passive snubber cell without additional active switches for battery charging systems. The proposed snubber finds its application in the front-end ac-dc converter of Plug-in Hybrid Electric ...
Aiswariya Sekar, Dhanasekaran Raghavan
doaj +1 more source
A control method for interleaved Boost PFC converter
Dianzi Jishu Yingyong, 2019 In order to solve the problem of complexity of zero-crossing detection and distortion of input current waveform, a novel control method is proposed for interleaved Boost PFC converter operates in critical conduction mode.
Lin Anna, Xie Yunxiang
doaj +1 more source
Computation of transient electromagnetic fields due to switching in high voltage substations [PDF]
, 2010 Switching operations of circuit breakers and disconnect switches radiate transient electromagnetic fields within high-voltage substations. The generated fields may interfere and disrupt normal operations of electronic equipment.
Siew, W.H., Musa, B.U., Judd, M.D.
core +4 more sources
Optimization of TSPWM for Common-Mode Voltage Reduction in Vehicular Electric Drive System
World Electric Vehicle Journal, 2021 Common-mode voltage can be reduced effectively by optimized modulation methods without increasing additional costs. However, the existing methods cannot satisfy the requirements of the vehicular electric-drive application.
Shang Jiang, Yuan Wang
doaj +1 more source
Digitally Controlled Zero-Voltage-Switching Quasi-resonant Buck Converter [PDF]
, 2015 Digitally-Controlled Two-Phase Zero-Voltage-Switching Quasi-Resonant Buck Converter Brian Luc This thesis entails the design, construction, and performance analysis of a digitally-controlled two-phase Zero-Voltage Switching Quasi-Resonant (ZVS-QR) buck ...
Luc, Brian R
core +1 more source
Inverter optimization of soft-switching DC-DC converter*
AutomatikaThe paper describes the influence of the magnetizing inductance of the transformer on zero-voltage switching of the primary transistors in a soft-switching full-bridge dc-dc converter with a controlled rectifier and turn-off snubber.
Marek Pastor +3 more
doaj +1 more source
Matlab/Simulink Modeling of Parallel Resonant DC Link Soft-Switching Four-leg SVPWM Inverter [PDF]
Iraqi Journal for Electrical and Electronic Engineering, 2015 This paper suggests the use of the traditional parallel resonant dc link (PRDCL) circuit to give soft switching to the Four-leg Space Vector Pulse Width Modulation (SVPWM) inverter.
Riyadh G. Omar, Rabee' H. Thejel
doaj
A new soft‐switching high step‐down DC‐DC converter for voltage regular module application
IET Circuits, Devices and Systems, 2022 This study proposes a high step‐down DC‐DC converter with minimum elements. In the proposed converter, soft switching condition is provided with only one auxiliary switch, which simplifies the structure of the converter.
Mahmood Vesali +2 more
doaj +1 more source
Zero Voltage Switching Converters
, 2014 Contact is the principal method of applying loads between deformable solids,and therefore is present in a wide variety of mechanical components. In addition,contacts usually act as stress concentrations,and are thus probable locations for mechanical failure.
Prof. Shoaib M.Tamboli, +1 more
openaire +2 more sources