Results 1 to 10 of about 5,771 (204)
Extension of Zero Voltage Switching Capability for CLLC Resonant Converter [PDF]
TheCLLC resonant converter has been widely used to obtaina high power conversion efficiency with sinusoidal current waveforms and a soft switching capability. However, it has a limited voltage gain range according to the input voltage variation.
HwaPyeong Park +3 more
doaj +3 more sources
A Fixed Frequency Zero-Voltage-Switching On-Board EV Charger
For electric vehicle (EV) onboard charging, high efficiency and power density of the charger is required. Soft switching technique is an effective way to increase On-Board Charger (OBC) power density and efficiency.
Changsheng Hu +4 more
doaj +1 more source
Design of Mazzilli’s Zero Voltage Switching (ZVS) Circuit as Plasma Glow Discharge Generator [PDF]
Purification water has several methods; one of them is the plasma generation. The circuit used to generate plasma is Zero Voltage Switching (ZVS), where its use uses the resonance circuit concept. The main category to generate plasma glow discharge is the circuit should generate high voltage output with a current range from 10-6 A to 1 A. In this study,
Anisah Muthi’ah +3 more
openaire +2 more sources
This letter proposes a simplified zero‐voltage switching (ZVS) detection circuit and switching loss dynamic optimisation method. The proposed circuit and tuning method can automatically adjust the switching frequency of a synchronous buck converter to ...
Sizhao Lu, Xiaoting Deng, Siqi Li
doaj +1 more source
This paper presents a comprehensive analysis of zero-voltage-switching (ZVS) realization with an improved charge-based method by considering both voltage dependency parasitic capacitance and dead time in dual-active-bridge (DAB) converters, when the ...
Haoyu Zhang, Takanori Isobe
doaj +1 more source
High‐frequency single‐switch PFC with frequency‐modulation controlled class‐E2 converter
This paper presents a single‐switch zero‐voltage switching (ZVS) power‐factor correction converter based on the class‐E2 converter at 1 MHz switching frequency. A design method for ensuring the ZVS for the entire line‐voltage period is proposed.
Wenqi Zhu +5 more
doaj +1 more source
The isolated three-level DC/DC converter (ITLDC) can be used to charge electric vehicles. During the constant current charging stage, the ITLDC can be designed to realize nature zero voltage switching (ZVS).
Shaogui Fan +4 more
doaj +1 more source
48-V Input DC-DC High Step-Down Converter in GaN-Based Design
This paper presents a novel high step-down DC-DC converter based on a switched-capacitor resonant topology. It is presented in a 48/8 V version, which was verified by simulations and experiments.
Szymon Folmer +2 more
doaj +1 more source
Quadrilateral Current Mode Paralleling of Power MOSFETs for Zero-Voltage Switching
This paper proposes a generic zero-voltage switching (ZVS) scheme for parallel power MOSFETs. Uncoupled or inversely-coupled differential-mode (DM) commutation inductors are added to the midpoints (AC terminals) of parallel MOSFET half-bridges (HBs), and a time-delay-based control scheme is applied, generating a circulating current flowing through ...
Yanfeng Shen +5 more
openaire +1 more source
Zero-Voltage-Switching Analysis Model of the Triple-Active-Bridge Converter
This study aims to analyze the zero-voltage-switching (ZVS) region of a Triple-Active-Bridge (TAB) converter with five degrees of freedom. A TAB converter is an isolated converter derived from a dual-active-bridge (DAB) converter and composed of three ...
Hyung-Jun Byun +3 more
doaj +1 more source

