Results 21 to 30 of about 133,939 (299)

Characterization of ageing resistant transparent nanocrystalline yttria-stabilized zirconia implants. [PDF]

open access: yes, 2020
The "Window to the Brain" is a transparent cranial implant under development, based on nanocrystalline yttria-stabilized zirconia (nc-YSZ) transparent ceramic material.
Aguilar, Guillermo   +6 more
core   +1 more source

Study of the Synthesis of Zirconia Powder from Zircon Sand obtained from Zircon Minerals Malaysia by Caustic Fusion Method

open access: yesIndonesian Journal of Chemistry, 2020
The zircon powder from Zircon Minerals Malaysia is a pure premium grade zircon sand milled 1.5 µm that contain ZrSiO4, ZrO2, HfO2, SiO2, Al2O3, TiO2, and Fe2O3.
Istikamah Subuki   +3 more
doaj   +1 more source

Electrochemical characterisation of 3Y-TPZ-Fe2O3 composites [PDF]

open access: yes, 2003
The influence of the addition of ferric oxide to 3Y-TZP on the conductivity and microstructure of sintered Y-stabilised tetragonal zirconia ceramics (3Y-TZP) was investigated.
Boukamp, B.A.   +3 more
core   +3 more sources

Marginal Discrepancy and Internal Fit of Bi-Layered and Monolithic Zirconia Fixed Dental Prostheses: An In Vitro Study

open access: yesApplied Sciences, 2023
This in vitro study evaluated the influence of restoration design (bi-layered vs. monolithic) and manufacturing technique on the marginal discrepancy and internal fit of 3-unit zirconia fixed dental prostheses (FDPs).
Majed M. Alsarani   +4 more
doaj   +1 more source

ON THE PREPARATION OF ZIRCONIA. [PDF]

open access: yesJournal of the American Chemical Society, 1886
n ...
openaire   +1 more source

On the Dielectric Constant of Zirconia and Lime-zirconia

open access: yesZeitschrift für Naturforschung A, 1971
Abstract The dielectric constant of monoclinic zirconia and of lime-zirconia (up to a CaO content of 20% mole) has been measured at 25 °C by the powder method. For pure ZrO2 the D.C. is 13.5, while for lime-zirconia a non linear dependence on the CaO content has been observed in the measured range, with a maximum at about 14% mole CaO ...
Manlio Sanesi   +3 more
openaire   +1 more source

THE EFFECT OF COMPLETE AND PARTIAL CONTOUR ZIRCONIA COPINGS ON THE FRACTURE RESISTANCE OF ALL CERAMIC RESTORATIONS [PDF]

open access: yesAlexandria Dental Journal, 2018
INTRODUCTION Veneer chipping is a common failure of zirconia based restorations, especially in the presence of high occlusal loads. Modifying zirconia design may influence veneer chipping.
Sanaa H Abdel Kader   +2 more
doaj   +1 more source

Effect of Speed Sintering on Low Temperature Degradation and Biaxial Flexural Strength of 5Y-TZP Zirconia

open access: yesMolecules, 2022
Translucent zirconia is becoming the material of choice for the esthetic restorative material. We aimed to evaluate the surface structure, phase determination, translucency, and flexural strength of 5Y-TZP Zirconia (Katana STML Block and Disc) between ...
Suchada Kongkiatkamon   +1 more
doaj   +1 more source

A Comparative Study of Marginal Adaptation between Monolithic and Layered Zirconia Crowns: A Literature Review [PDF]

open access: yesJournal of Dental Materials and Techniques, 2022
Introduction: Marginal adaptation highly affects the long-term success of crowns. This study intends to investigate the marginal adaptation of monolithic zirconia and veneered zirconia crowns.
Ezatollah Jalalian, Verishe Rastin
doaj   +1 more source

Assessment and comparison of retention of zirconia copings luted with different cements onto zirconia and titanium abutments: An in vitro study

open access: yesThe Journal of Indian Prosthodontic Society, 2016
Aim: The purpose of this in vitro study was to assess and compare the retention of zirconia copings luted with different luting agents onto zirconia and titanium abutments.
Neelima Sreekumar Menon   +4 more
doaj   +1 more source

Home - About - Disclaimer - Privacy