Results 61 to 70 of about 293,660 (340)
Journal of Magnesium and Alloys, 2014 Previous studies have proved that the zirconium (Zr) alloying and grain refining performance of a Mg–Zr master alloy on Mg alloy is closely related to the distribution of Zr particle size, and a Mg–Zr master alloy with more Zr particles in size range of ...
Chengqi Wang +4 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi +3 more
wiley +1 more source
Insights into the accessibility of Zr in Zr/SBA-15 mesoporous silica supports with increasing Zr loadings [PDF]
Microporous and Mesoporous Materials, 2016 Oxide-promoted SBA-15 materials have been shown to be profitable in a wide variety of catalytic reactions of environmental interest. Zr-SBA-15 materials have been found to be of particular interest in hydrotreating, biomass conversion and Fisher–Tropsch synthesis.
Ogura, Masaru +7 more
openaire +2 more sources
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Yankuang ceshi, 2013 Zirconium titanium placer is an ore which is extremely difficult to be digested. It is almost insoluble in all kind of acid except HF. Moreover, Hf, Ti and Zr in the ore tends to hydrolyze to form insoluble partial hafnium acid, metatitanic acid and ...
ZHAO Qing-ling, LI Qing-cai
doaj
Lattice Stability and Elastic Properties of Zr-Ti-X Alloys (X = Al, V) by the First Principles Study
Metals, 2020 Based on a certain ratio of Zr and Ti atomic fractions according to Zr47Ti45Al5V3 (wt.%), the lattice constants, lattice stability, and elastic properties of Zr-Ti-X alloys (X = Al, V) in body-centered cubic (BCC) (β phase) and hexagonal close-packed ...
Wenxiong Duan +4 more
doaj +1 more source
Original dataset for ID 162 Zr in Thermophysical Property Database
This is the original dataset for ID 162 Zr in Thermophysical Property Database (https://thermophys.nims.go.jp/thermophysicalproperty/experiments/162). The dataset was obtained at Japan Aerospace Exploration Agency (JAXA), and is a part of Thermophysical ...
core +1 more source
Advanced Engineering Materials, EarlyView.Trace additions of Sn and Sr combined with a two‐step aging treatment are shown to enhance the microstructure and performance of Al–Zr–Sc conductor alloys. Strength and electrical conductivity increase concurrently through accelerated precipitation of fine Al3(Sc, Zr) precipitates and improved dislocation resistance, offering a cost‐effective pathway ...
Quan Shao +3 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.New features on yttria‐stabilized zirconia after exposure at 1500°C: Newly discovered pyramidal structures on an old material. After exposure at 1550°C on the cross section of YSZ new features, namely pyramidal structures are discovered. These structures grow with time, increase in numbers, appear as singularities, are often arranged in strings, and ...
Doris Sebold +2 more
wiley +1 more source
Materials Research ExpressDue to it has large saturation magnetization (Ms), high magnetocrystalline anisotropy field and high ferromagnetic resonance (FMR) frequency, barium ferrite (BaM) has attracted more and more attentions in the fields of magnetic recording media, permanent
Wenfei Xie +3 more
doaj +1 more source