Results 21 to 30 of about 565 (152)
China’s CBM exploration and production and associated technological advancements: A review and reflections [PDF]
Objective and Methods Based on extensive scientific and technical literature and technical data on coalbed methane (CBM) exploration and production projects, this study conducted a comparative analysis of the development process and latest advances in ...
Jianping YE
core +1 more source
针对川西油田水平井机械钻速低、起下钻频繁和钻井周期长的问题,在底部钻具组合力学分析的基础上,对水平段稳斜钻具组合进行优选,并提出了以水平段轨迹控制技术、井眼清洁控制技术、PDC钻头优选技术、润滑防塌钻井液技术和无线随钻测量技术为核心的川西中浅层气藏千米水平段一趟钻关键技术。应用一趟钻关键技术在川西地区完成了多口井的施工,与2011年完钻同类型水平井相比,钻井技术指标大幅提升,沙溪庙组水平井在水平段长增加434 m的情况下,钻井周期缩短13.71%,机械钻速提高37.99%;蓬莱镇组水平井钻井周期缩短38.
崔杰, 纪友亮
doaj
Production capacity prediction of U-shaped horizontal wells for in-situ pyrolysis of tar-rich coal: Experimental and numerical simulation study [PDF]
Under the goal of “dual carbon”, “taking hydrogen and retaining carbon” has become an inevitable choice for the clean utilization of coal, and underground coal pyrolysis provides a new idea for increasing domestic tar and gas production.
Bo REN +10 more
core +1 more source
致密油开发目前多采用工厂化长位移水平井的方式,水平井段的长度直接影响到致密油藏开发的效率。分析了制约致密油水平井水平段延伸长度的主要因素,采用实测数据反演摩阻系数法预测井口载荷以及考虑接头环空压耗的计算模型,指出额定泵压是水平段延伸长度的主要限制因素,较为准确地预测了致密油长位移水平井水平段安全延伸长度。在额定泵压30 MPa,排量14 L/s,完井井眼尺寸φ152.4 mm的情况下,新疆昌吉致密油水平井的最大安全延伸长度为3 000 m。
刘洋 +5 more
doaj
Fluid–solid coupling productivity analysis of multi-stage fractured horizontal wells in shale reservoirs [PDF]
Starting from the micro/macro dynamics of seepage behavior, stress-sensitive experiments are conducted to investigate the fluid–solid coupling and fluid flow law in shale gas reservoirs.
Ming YUE +3 more
core +1 more source
Review and prospect of coal rock hydraulic fracturing physical experimental research [PDF]
Physical simulation of hydraulic fracturing is an approximate representation of fracture evolution and its dynamic process, which represents an important direction of fracture evolution research.
Le LIU +8 more
core +1 more source
热采水平井蒸汽吞吐时水平段吸汽不均衡,造成水平段动用不均。鉴于此,对热采水平井改善吸汽剖面技术进行研究。首先,建立油藏井筒流动耦合模型及储层热流变形三场耦合模型,定量分析了油层物性参数、非均质性及注汽口位置对吸汽剖面的影响。然后,根据上述分析结果,设计了均衡注汽完井工艺管柱。该管柱可实现注采一体化及均匀注汽以及长水平段、非均质储层的均匀注采。现场应用结果表明,热采水平井改善吸汽剖面技术可以改善热采水平井长水平段的吸汽剖面,实现均衡注汽,提高水平井的动用程度。
岳慧 +4 more
doaj
Extraction mode and engineering demonstration of pressure relief three-dimensional of multi-coal seams in Pingdingshan mining area [PDF]
There are many coal seams and gas-bearing strata in Pingdingshan mining area, and the amount of underground gas control project is large and difficult.
Jinsheng JIA, Xiaoming NI, Yanhe LI
core +1 more source
针对日光油田Cardium组致密油开发需要大量高效低成本的水平井钻井和多段压裂等特点,研究并应用了致密油大位移水平井钻井技术。考虑大位移水平井复合钻井的特殊要求,建立了三段组合圆弧井眼轨道模型,深入研究了井身结构、油基钻井液、钻头优化和钻具组合等关键技术。对3口先导试验大位移水平井丛式井组和3口相邻水平井丛式井组的经济效益进行了评价,评价结果表明,其平均每米水平段长度的钻完井费用比相邻丛式井组节约22%、钻井周期比相邻丛式井组减少42%,其初始平均日产量和6个月总产量分别是相邻丛式井组的1.6倍和1 ...
谈 +4 more
doaj
Evolution of broken pressure and fracture morphology in indirect fracturing for broken-soft coal [PDF]
Indirect fracturing using a horizontal well in roof is a promising technology for methane exploitation in broken soft and low-permeability coal seams. Stratum-penetration fracturing and a complex fracture network with good conductivity are two keys for ...
Dijie ZHU +5 more
core +1 more source

