Results 11 to 20 of about 1,407,272 (151)

原位TiC/金属基激光熔覆涂层的微结构特征

open access: yes, 1998
利用激光熔覆制备了原位形成TiC陶瓷颗粒增强金属基复合材料涂层,TiC为熔覆时原位形成。颗粒细小弥散,具有内晶型及密度梯度分布特征;HREM观察表明,TiC/基体界面结构具有洁净及微晶过渡特征,无界面反应物 ...
陈光南, 武晓雷
core   +4 more sources

人工岛建设对龙口湾表层沉积物粒度及黏土矿物组成特征的影响

open access: yes, 2016
通过对2013年采自龙口湾的表层沉积物样品进行激光粒度分析和X-射线衍射(XRD)分析,根据其表层沉积物粒度及黏土矿物组成分布特征,来探讨大规模人工岛建设对龙口湾表层沉积物粒度分布及黏土矿物组成特征的影响。结果表明,龙口湾沉积物粒度以粉砂为主(62.90%),黏土(18.05%)和砂(19.05%)的质量分数相近。龙口湾表层沉积物的黏土矿物组成与莱州湾整体沉积物组成相近,其不同组分质量分数表现为伊利石>蒙皂石>绿泥石>高岭石,但个别矿物的含量仍存在一定差异。表层沉积物粒度分布及黏土矿物的组合特征表明 ...
祝贺   +5 more
core   +1 more source

A Review and Critique of Methods and Knowledge Gaps in Quantifying Spillover Effects from Protected Areas

open access: yesConservation Biology, EarlyView.
Abstract The sustainability of area‐based conservation initiatives depends on their value to society. Conservation often focuses inside protected areas, but the impacts of protected areas beyond their boundaries (spillovers) are critical for their social license.
Ilaria Gliottone   +5 more
wiley   +1 more source

Synergistic B/Si Microalloying Induced Wear Resistance Improvement in FeCoNiCrCu High‐Entropy Alloy Coatings Prepared by Annular Oscillating Laser Deposition

open access: yesRare Metals, Volume 45, Issue 11, November 2026.
ABSTRACT To address the insufficient wear resistance of high‐entropy alloy (HEA) coatings under extreme conditions, FeCoNiCrCu and FeCoNiCrCuB0.03Si0.03 microalloyed coatings were fabricated via annular oscillating laser deposition. This work systematically investigated the effects of synergistic B/Si addition on their phase composition, microstructure,
Tao Wang   +6 more
wiley   +1 more source

Low‐Temperature Solid‐State Sintering of High‐Strength and Electrically Conductive Silicon Carbide With Direct Current Flow and In Situ Graphitization

open access: yesRare Metals, Volume 45, Issue 11, November 2026.
ABSTRACT Silicon carbide (SiC) is an ultra‐hard ceramic material and is intrinsically difficult to sinter. Pressureless solid‐state sintering (PS) typically requires high temperatures exceeding 2200°C and a prolonged heating cycle, whereas liquid‐phase sintering lowers the processing temperature at the expense of high‐temperature mechanical performance.
Meicen Fan   +5 more
wiley   +1 more source

Lattice‐Defect‐Coordinated Microstructural Continuity and Mechanical Compatibility in LPBF‐Fabricated CoCrNi/316L Bimetallic Structures

open access: yesRare Metals, Volume 45, Issue 10, October 2026.
ABSTRACT Bimetallic structures fabricated by laser powder bed fusion (LPBF) provide an effective strategy for achieving multifunctional integration, yet interfacial structural continuity and the role of lattice defects remain insufficiently understood.
Jinguo Ge, Shuo Yin
wiley   +1 more source

In Situ Rare Earth Nanoparticle Reinforcement of NiCoCrAlYTa Coatings via HCPEB Modification: Insights Into Early Oxidation Behavior and Microstructural Evolution

open access: yesRare Metals, Volume 45, Issue 9, September 2026.
ABSTRACT NiCoCrAlYTa coatings are widely used as bond coats in thermal barrier coating (TBC) systems for gas turbines and aeroengines to provide oxidation resistance and support the formation of a protective thermally grown oxide (TGO). Herein, high‐current pulsed electron beam (HCPEB) modification was utilized to strengthen a NiCoCrAlYTa coating by ...
Xiangcheng Li   +6 more
wiley   +1 more source

Enhanced Oxygen Reduction Reaction Performance of Fe‐N4 Single‐Atom Catalysts Through Fe3C Coupling

open access: yesRare Metals, Volume 45, Issue 9, September 2026.
ABSTRACT Understanding the electronic factors contributing to the high oxygen reduction reaction (ORR) activity of Fe‐N4 sites remains a significant challenge due to the localized Fe 3d orbitals and their sensitivity to the coordination environment.
Shichang Cai   +19 more
wiley   +1 more source

The Formation and Hardening Mechanisms of Multiscale Gradient Structures Tailoring by Explosive Hardening and Annealing in Commercially Pure Titanium

open access: yesRare Metals, Volume 45, Issue 8, August 2026.
ABSTRACT Gradient structures (GS) introduced by plastic deformation have been shown to effectively enhance the surface properties of metallic materials. However, the GS fabricated by existing methods often suffers from limited hardening depth and limited control over the GS layer, which constrain their engineering applications.
Yansong Guo   +5 more
wiley   +1 more source

非饱和颗粒介质土水特征曲线的离散元模拟

open access: yes, 2013
提出一种"气泡液体重分布-颗粒受力折减"的计算方法解决上述问题,首次将三维颗粒离散元模拟非饱和颗粒介质的能力扩展到环锁区和毛细区。应用该方法,得到了三维颗粒介质完整的土水特征曲线。进一步,模拟了砂土和粉土的土水特征曲线,结果表明颗粒粒径是影响土水特征曲线的重要因素 ...
李家春, 王晓亮
core   +2 more sources

Home - About - Disclaimer - Privacy