Results 31 to 40 of about 1,407,272 (151)

Encapsulation of Bi2S3 Within Multifunctional Sulfurized Polyacrylonitrile Matrix Enables High‐Performance Wide‐Temperature Sodium/Potassium‐Ion Batteries Through Solid–Solid Conversion

open access: yesRare Metals, Volume 45, Issue 6, June 2026.
ABSTRACT With high theoretical capacity and low cost, bismuth sulfide (Bi2S3) demonstrates considerable potential as an anode for sodium/potassium‐ion batteries (SIBs/PIBs). Unfortunately, significant volume variation, low electrical conductivity, and dissolution of polysulfides drastically weaken their intrinsic merits.
Fuyu Xiao   +11 more
wiley   +1 more source

Complexion‐Mediated Dislocation Transfer Enables Exceptional Strength‐Toughness Synergy in Multicomponent‐Alloy Bonded Hardmetal

open access: yesRare Metals, Volume 45, Issue 5, May 2026.
ABSTRACT The inherent brittleness of hardmetals stems from the rigid covalent bond in the ceramic matrix and the sharp ceramic/metal interface, which restricts the nucleation and motion of dislocations. In this study, a novel strategy is proposed to activate significant dislocation behaviors in the WC matrix by employing a non‐equiatomic CoNiFeCr ...
Cheng Qian   +9 more
wiley   +1 more source

Sustainable Nanocellulose‐Based Materials for Environmental Remediation: Structure–Function Relationships and Applications

open access: yesRare Metals, Volume 45, Issue 5, May 2026.
ABSTRACT Environmental pollution across water, air, and soil systems poses escalating threats to human health and ecosystem stability, driven by heavy metals, persistent organic pollutants, particulate matter (PM), bioaerosols, and toxic gases. Conventional remediation technologies often suffer from limited selectivity, insufficient efficiency, and the
Junjie Qi   +6 more
wiley   +1 more source

Tailoring Differentiated Multiscale Microstructure to Enhance the Mechanical Properties of Additively Manufactured AlCoFeNi2 at Room and High Temperatures via Annealing

open access: yesRare Metals, Volume 45, Issue 4, April 2026.
ABSTRACT Additively manufactured AlCoFeNi series eutectic high‐entropy alloys (EHEAs) exhibit nonequilibrium dual‐phase microstructure in the as‐printed state, allowing them to be easily tailored through annealing to explore their strength–toughness potential.
Huidong Wu   +13 more
wiley   +1 more source

洛川黄土碎屑锆石的粒度特征及其古气候意义

open access: yes, 2011
通过对洛川剖面12个层位的锆石粒度分析测量,探讨洛川黄土-古土壤及新近纪红黏土中碎屑锆石的粒度特征及其反应的古气候变化特征。方法利用Quanta400 FEG场发射环境扫描电子显微镜获得锆石的二次电子图像,并用Scandium软件对锆石的二次电子图像进行粒径测量。结果第四纪黄土-古土壤及新近纪红黏土中存在大量碎屑锆石,除L24层黄土外,其余黄土层中的锆石粒度均显示出相似的分布特征,主要粒级分布于20~60μm之间,与全岩粒度相比,其中值粒径、平均粒径均有差异 ...
孙博亚[1]   +3 more
core   +1 more source

浑水颗粒级配对一维入渗规律及致密层形成特性的影响

open access: yesShuitu Baochi Xuebao, 2021
为探明浑水不同泥沙颗粒级配对入渗规律及致密层形成特性的影响,通过室内土柱垂直入渗试验,选取4种不同物理性黏粒含量的泥沙(5.59%,9.87%,18.43%,39.43%),研究落淤层厚度、湿润锋运移距离、累积入渗量随入渗时间变化特征,并测定落淤层和入渗结束后不同深度(0—1,1—2 cm土层)土壤的颗粒级配。结果表明:浑水泥沙中物理性黏粒含量越大,落淤层厚度越大;同一入渗时刻湿润锋运移距离和单位面积累积入渗量随物理性黏粒含量的增大而减小。落淤层厚度随时间变化符合幂函数关系(R2 > 0.9 ...
康守旋   +4 more
doaj  

准噶尔中南部沙尘暴源区地表沉积物粒度特征

open access: yes, 2005
对准噶尔中南部沙尘暴源区———艾比湖地区、克拉玛依农业开发区和古尔班通古特沙漠地表沉积物粒度组成、传统粒度参数及分维值进行了分析计算,结果表明:艾比湖流域及克拉玛依开发区广泛分布的沙质、粘土质、盐土荒漠区,特别是春季翻耕的大面积裸露农田地表物质含有大量小于0.063mm的粉砂和粘土,且粒度分维值较高,是沙尘暴的丰富物源。古尔班通古特沙漠风成沙粒径较粗,分维值较低,加之较好的植被状况,沙尘暴发生频数相对较低。粒度参数C-M图、MzS0散点图和粒度分维值可以有效地表征地表松散物质的搬运-沉积特征 ...
钱亦兵,吴兆宁,陈冬梅,张立运,汪溪远,李冬梅
core  

Accelerated Ordering of Cu Atoms and Synergistic Dual Anisotropy for Enhanced High‐Frequency Soft Magnetic Properties in Fe‐Based Alloys

open access: yesRare Metals, Volume 45, Issue 4, April 2026.
ABSTRACT The inherent trade‐off between high saturation induction (Bs) and low core loss in soft magnetic materials presents a challenge in the development of high‐frequency power electronics. Here, a processing approach that combines accelerated Cu ordering with dual magnetic anisotropy control in high‐Bs Fe‐based nanostructured cores is examined ...
Xiaoying Li   +11 more
wiley   +1 more source

青藏高原爬坡沙丘地表沉积物特征分析——以柴达木盆地托拉海河为例

open access: yesShuitu Baochi Xuebao, 2018
为了阐明青藏高原爬坡沙丘的物源及沉积学意义并揭示其形成机理,对托拉海河爬坡沙丘进行断面采样,分析爬坡沙丘不同地形部位的粒度与地球化学元素特征。结果表明,托拉海河爬坡沙丘地表沉积物的粒度组成总体以极细砂、细砂、中砂为主,粒度特征表现出明显的风成特点;不同地形部位,粒度特征呈现不同的递变规律,自河床到迎风坡顶粒径变粗,分选变好,迎风坡顶到背风坡,粒径粗细混杂,分选变差。沉积物地球化学元素组成以Si、Al、Ca为主,和上陆壳(UCC)相比,除Co、As、CaO、SiO2以外,其余元素都有一定的亏损 ...
董苗, 严平, 孟小楠, 吴伟
doaj  

The Dependence of Properties on Structural Features in Macro/Micro Levels for PBF‐LB Fabricated Porous NiTi Alloy

open access: yesRare Metals, Volume 45, Issue 2, February 2026.
ABSTRACT Porous NiTi alloys are widely used in biomedical and engineering fields. Using the PBF‐LB technique, the TPMS and Voronoi porous parts with a porosity of ∼67% and a minimum feature size of 0.15 ± 0.02 mm were fabricated. Although the bulk sample fabricated with the same parameters is defect‐free, μ‐CT reconstruction on the porous sample ...
Wen‐Hao Zeng   +7 more
wiley   +1 more source

Home - About - Disclaimer - Privacy