Results 31 to 40 of about 107,323 (154)
Insights Into the Temperature‐Dependent Oxidation Mechanism of Metallic Cerium in H2O‐N2 Atmospheres
ABSTRACT Metallic cerium (Ce), a widely used surrogate for actinide metals, enables mechanistic studies of reactions in complex gas environments under controlled and safer laboratory conditions. Here, the oxidation behavior of Ce in H2O‐N2 mixed atmospheres was investigated from 200°C to 350°C using in situ thermogravimetry–mass spectrometry, in situ X‐
Kun Huang +10 more
wiley +1 more source
采用浊度法检测含有微量细小的分子筛颗粒和金属镍颗粒的悬浮液中微量固体颗粒浓度,并对相关因素的影响进行了研究。结果表明:在实验范围内,悬浮液微细颗粒的浓度与悬浮液浊度成线性关系;对微细颗粒悬浮液,采用d32(Sauter直径)作为平均直径比采用中位直径d50更能反应出粒径因素对浊度的影响。
孟庆功 +3 more
doaj +2 more sources
ABSTRACT A facile coprecipitation‐pyrolysis strategy was employed to fabricate Cu/Co nanoparticles (NPs) embedded in nitrogen‐doped carbon matrices (Cu/Co@N‐C) through the carbonization of CuCo‐MOF precursors. Moreover, monometallic counterparts of Cu@N‐C and Co@N‐C were also prepared via carbonization of bimetallic CuZn‐MOF and CoZn‐MOF, respectively.
Weinan Yao +7 more
wiley +1 more source
为今后实现自然积污规律研究和防污的差异化,对污秽颗粒等效简化模型、大气总悬浮颗粒物(TSP)的粒径分布函数、绝缘表面污秽主要化学成分对应TSP的粒径分布进行了综述和分析,认为可以污秽颗粒可等效简化为球体,使用空气动力学粒径衡量其粒径;建立TSP粒径分布函数拟合模型;分析认为化学成分Ca2+、SO42-、Cl-、SiO2、Al2O3在TSP中的粒径主要分布在1.810μm,010μm,1.810μm,30-40μm,40μm50μm的范围内,最后对自然积污规律研究和防污的差异化进行了展望。
李恒真 +5 more
doaj
ABSTRACT The commercialization of lithium–sulfur batteries (Li–S batteries) has been hindered by the shuttle effect of lithium polysulfides (LiPSs) and sluggish redox kinetics. In this study, we constructed a three‐dimensional hollow conductive network host material for sulfur with synergistic enhancement effects.
Jie Yang +6 more
wiley +1 more source
ABSTRACT Due to their exceptional porosity, structural versatility, and modular coordination chemistry, metal–organic frameworks (MOFs) have emerged as versatile platforms for targeted drug delivery. These structures enable fine‐tuning of pore size, surface activity, and framework stability for the encapsulation of a broad range of therapeutics ...
Rui Hua +9 more
wiley +1 more source
ABSTRACT To overcome the challenges of the strength‐ductility trade‐off in laser additively manufactured (LAM) titanium alloys, and to avoid the intragranular microstructure degradation often caused by an exclusive focus on grain equiaxialization, this work proposes a novel strategy of “grain morphology‐intragranular microstructure co‐optimization ...
Kexin Zhao +8 more
wiley +1 more source
采用颗粒粒径选择压与沉降速率选择压相结合的策略,在120 d内成功培养出白色除磷颗粒污泥,颗粒成熟后在反应器内因粒径分化出现分层,按粒径筛分为R1(<2 mm)、R2(2~4 mm)、R3(4~7 mm)、R4(>7 mm)共4组,考察了白色颗粒污泥的除污效能和理化性质。除污效能实验结果表明,在4组粒径范围内,白色颗粒污泥对COD去除效果均较好;4~7 mm的颗粒污泥对TP的去除率最优,达到99.94%;TN的去除率随着粒径的增大而增大,>7 mm的颗粒污泥对TN的去除率最优,达到82.
徐明煌 +3 more
doaj +2 more sources
为研究动车组支柱绝缘子伞裙不同部位积污特性,将动车组支柱绝缘子伞裙分为迎风面、背风面和侧风面,建立了积污特性的流场计算模型,以质量沉积率为表征积污特性的参数,分析了不同部位质量沉积率与污秽颗粒粒径、气流速度之间的关系,比较了不同部位质量沉积率的差异性。仿真结果表明:迎风面和侧风面质量沉积率随污秽颗粒粒径的增大而增大,背风面质量沉积率随污秽颗粒粒径的增大而减小;不同部位质量沉积率与气流速度的关系受污秽颗粒粒径的影响,当污秽颗粒的粒径大于10μm时,随着气流速度增大,迎风面和侧风面质量沉积率增大 ...
律方成 +5 more
doaj
ABSTRACT The demand for advanced aerospace components necessitates near‐α titanium alloys with enhanced high‐temperature performance and compatibility with additive manufacturing (AM). To address this, an in situ alloying strategy was employed to co‐modify a Ti‐6.5Al‐2Zr‐Mo‐V alloy with Si and Y during laser powder bed fusion.
Zishuo Ma +10 more
wiley +1 more source

