Results 71 to 80 of about 74,738 (303)

Health Care Use Among Patients Presenting to Emergency Department for Gout Flares in Ontario, Canada: A Population‐Based Health Systems Analysis

open access: yesArthritis Care &Research, EarlyView.
Objective We characterized emergency department (ED) gout visits and identified patient characteristics and health services patterns contributing to ED presentations. Methods We conducted a population‐based study of ED gout visits in Ontario, Canada, between 2014 and 2023.
Timothy S. H. Kwok   +7 more
wiley   +1 more source

A virtual instrumentation of electric drive systems for automation and testing

open access: yes, 2000
The virtual instrumentation concept has been applied to AC and DC type electric drives. Visual Designer is used for a DC motor and LabView is used for a three-phase, delta connected induction motor.
Eren, H., Fung, C.C.
core  

Matrix Converter sebagai Pengendali Kecepatan Motor Induksi 3 Fase dengan ISVM

open access: yesJurnal Elkomika, 2020
ABSTRAK Makalah ini membahas matrix converter digunakan sebagai pengendali kecepatan motor induksi 3 fase pada sistem closed loop. Matrix converter merupakan konverter AC – AC yang efektif dan efisien untuk menghasilkan tegangan dan frekuensi keluaran ...
MENTARI PUTRI JATI   +3 more
doaj   +1 more source

Suppression of common-mode voltage in a PWM rectifier/inverter system

open access: yes, 2001
This paper proposes a PWM rectifier/inverter system capable of suppressing not only supply harmonic currents but also electromagnetic interference (EMI).
S. Ogasawara   +3 more
core   +1 more source

Torque ripple reduction of a direct-drive permanent-magnet synchronous machine by material-efficient axial pole pairing [PDF]

open access: yes, 2011
This paper investigates a material-efficient axial pole pairing method for torque ripple reduction in a direct-drive outer-rotor surface-mounted permanent-magnet synchronous machine.
Patrick Chi-Kwong Luk   +3 more
core   +1 more source

Electrochemical Evaluation of Compressed Selective Laser Melted AlSi7Mg and AlSi10Mg Alloys in Chloride Environment

open access: yesAdvanced Engineering Materials, EarlyView.
The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin   +2 more
wiley   +1 more source

Innovative Processing of Compacted Waste Aluminum Alloy Powders via Controlled Remelting and Solidification

open access: yesAdvanced Engineering Materials, EarlyView.
This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira   +4 more
wiley   +1 more source

Parking Braking System Design for AC Drive Electric Locomotive

open access: yes机车电传动, 2015
Taking parking braking system for HXD1D electric locomotive as an example, the parking braking system control circuit theory, relationship between parking braking and control system, JPXZ-2 disk braking device and parking braking calculation were ...
LIU Dexue   +3 more
doaj  

Creep‐Induced Microstructural Evolution in an A2‐B2 Superalloy

open access: yesAdvanced Engineering Materials, EarlyView.
A 27.3Ta‐27.3Mo‐27.3Ti‐8Cr‐10Al (at.%) refractory high‐entropy alloy with precipitation‐strengthened A2‐B2 microstructure was studied by creep tests at 1030°C, which demonstrate a transition in deformation mechanisms in the range of 100–150 MPa applied stress. This is associated with changes in dislocation–precipitate interactions. Relevant deformation
Liu Yang   +10 more
wiley   +1 more source

Simulation Analysis of Direct Drive Volume Control of Electro-hydraulic Servo System

open access: yes, 2007
Direct Drive Volume Control (DDVC) of Electro-hydraulic Servo system is a new type energy saving system.The construction end characteristics of DDVC of Electro-hydraulic Servo System are presented. On the background for application to the hydro former ...
Zhao MY(赵明扬), Zhou JL(周加龙)
core   +1 more source

Home - About - Disclaimer - Privacy