Results 81 to 90 of about 195,584 (269)
This work presents a continuous linear gradient catalyst layer design, a general strategy for improving membrane electrode assemblies across electrochemical devices. Fabricated via a dual‐nozzle spray coating method, the architecture controls the Pt/carbon ratio, ionomer content and ionomer type across the catalyst layer, enhancing proton conduction ...
Shangwei Zhou +15 more
wiley +1 more source
The new power system is characterized by high penetration of renewable energy sources and a high proportion of power electronics (namely, double‐high).
Yao Qin +5 more
doaj +1 more source
Electroactive Liquid Crystal Elastomers as Soft Actuators
Electroactive liquid crystal elastomers (eLCEs) can be actuated via electromechanical, electrochemical, or electrothermal effects. a) Electromechanical effects include Maxwell stress, electrostriction, and the electroclinic effect. b) Electrochemical effects arise from electrode redox reactions.
Yakui Deng, Min‐Hui Li
wiley +1 more source
An All‐Optical Driven Bio‐Photovoltaic Interface for Active Control of Live Cells
Bio‐photovoltaic Interface (BIO‐PV‐I) for live cell manipulation is presented. BIO‐PV‐I can be activated non‐invasively and remotely to control the spatial motility, adhesion, and morphology of cells adhering to it. BIO‐PV‐I uses a patterned light‐induced electric potential in iron‐doped lithium niobate crystals whose light‐driven and reversible nature,
Lisa Miccio +8 more
wiley +1 more source
Research on the Power Quality Improvement Using AC/DC/AC Type Power Electronic Transformer
It designed a power electronic transformer (PET) with AC/DC/AC topological structure. Decoupling control method for active power and reactive power was adopted in the input stage, and the open-loop control was chosen in the middle stage to achieve fast ...
DENG Xiang +5 more
doaj
A roll‐to‐roll exfoliation method is demonstrated that preserves the crystallographic alignment of anisotropic 2D materials over large areas, enabling scalable fabrication of directional electronic and optoelectronic devices. Abstract Anisotropic 2D materials such as black phosphorus (BP), GeS or CrSBr, exhibit direction‐dependent optical and ...
Esteban Zamora‐Amo +14 more
wiley +1 more source
A FeN4─O/Clu@NC‐0.1Ac catalyst containing atomically‐dispersed FeN4─O sites (medium‐spin Fe2+) and Fe clusters delivered a half‐wave potential of 0.89 V for ORR and an overpotential of 330 mV at 10 mA cm−2 for OER in 0.1 m KOH. When the catalyst was used in a rechargeable Zn–air battery, a power density of 284.5 mW cm−2 was achieved with excellent ...
Yongfang Zhou +8 more
wiley +1 more source
Trap state engineering in inverted organic photodetectors (OPDs) is achieved via combined layer‐by‐layer (LbL) processing and poly(N‐vinylcarbazole) (PVK) incorporation. LbL reduces the trap density while PVK additives gradually shift trap states from shallow band‐edge to deep mid‐gap levels, tailoring the energy distribution.
Jingwei Yi +10 more
wiley +1 more source
Mechanotransducing Organic Electrochemical Diode for Crosstalk‐Inhibited Artificial Skin
An innovative approach is presented to a stretchable mechanotransducing diode that unifies rectification and tactile‐sensing functionality. This approach enables to fabricate the diode that maintains a large rectification ratio (5 × 102) at a high operational frequency (100 Hz).
Taeyeong Kim +7 more
wiley +1 more source
Enzymatically crosslinked gelatin‐based organohydrogels, fabricated through a fully bio‐based and scalable process, exhibit exceptional strain and temperature sensing capabilities with minimal interference from environmental humidity. These transparent, stretchable, and ionically conductive materials operate without synthetic fillers or dopants.
Pietro Tordi +7 more
wiley +1 more source

