Results 151 to 160 of about 77,987 (293)

STANDARDIZATION OF CERVICAL VESTIBULAR EVOKED MYOGENIC POTENTIAL TESTS WITH AIR AND BONE CONDUCTION STIMULATION IN HEALTHY ADULTS

open access: yes, 2020
Objective: The aim of this study was to obtain normative data on Cervical Vestibular Evoked Myogenic Potentials (cVEMP) test inadult age group to use as a differential diagnostic test in our clinic.
Altuntaş, Emine Elif   +2 more
core  

A Dislocation Perspective on Strength and Toughness in Ceramics

open access: yesAdvanced Engineering Materials, EarlyView.
Dislocations in ceramics enjoy a long but yet under‐appreciated history. The three research waves for dislocations in ceramics highlight the topic evolution over the last 90 years. This review focuses on the impact of dislocation on strength and toughness in ceramics.
Xufei Fang
wiley   +1 more source

Air cooled engine cooling fins redesigned by use of the membrane analogy for heat conduction

open access: yes, 1948
The purpose of this investigation is to determine the feasibility of applying the two-dimensional heat conduction membrane analogy to the redesign of cooling fins of air-cooled engines --Preface, page ...
Miller, Eberhard Hammel
core  

Feasibility of Nitrogen as a Carrier Gas for Inconel Cold Spray in Hydropower Application

open access: yesAdvanced Engineering Materials, EarlyView.
N2, despite being nearly two orders of magnitude cheaper than He, is a feasible carrier gas for cold spray Inconel coatings in hydropower repair applications when higher gas temperature and pressure are used. Reducing powder size significantly improved cavitation resistance, while the addition of fine chromium carbide particles further enhanced erosion
Tianhao Wang   +4 more
wiley   +1 more source

Investigation into the switching characteristics of gold coated carbon nanotubes under low current conditions

open access: yes, 2014
Gold coated multi-walled carbon nanotubes (Au/MWCNT) are a novel composite material, which have been investigated for use as an electrical contact surface.
Chianrabutra, Chamaporn
core  

Machine Learning‐Supported Analysis for Predicting and Visualizing Nonlinear Relationships Between Material Properties in Electroplated Chromium Layers

open access: yesAdvanced Engineering Materials, EarlyView.
This study applies machine learning regression to predict chromium layer thickness in decorative trivalent chromium electroplating, using 441 experiments from laboratory‐scale (1L) and pilot‐scale (14L) setups. Tree‐based models, particularly CatBoost, outperformed linear regression by capturing nonlinear parameter interactions (R2$R^2$ up to 0.77 ...
Christoph Baumer   +4 more
wiley   +1 more source

Microstructure, Thermal Transport, and Dry‐Sliding Tribology of Powder‐Metallurgy Al7075 Composites Reinforced With Sol–Gel‐Derived ZnO–rGO Hybrid Nanoparticles

open access: yesAdvanced Engineering Materials, EarlyView.
Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal   +3 more
wiley   +1 more source

Active Corrosion Protection of Sintered AA7075 Aluminum Alloy via Mn Powder Addition

open access: yesAdvanced Engineering Materials, EarlyView.
AA7075 containing Mn‐rich particles is fabricated via spark plasma sintering using AA7075 and Mn powders. Corrosion resistance is evaluated through dip‐and‐dry tests using 0.1 M NaCl (pH 6.0), and mass loss decreases with increasing Mn addition. Mn‐rich particles function as a source of Mn ions, and formation of Mn‐accumulation films on Cu‐containing ...
Ko Ebina, Masashi Nishimoto, Izumi Muto
wiley   +1 more source

Home - About - Disclaimer - Privacy