Results 81 to 90 of about 77,987 (293)

Experimental Evaluation of 100Cr6 Steel Microindented Surfaces Under Lubricated Nonconformal Point Contacts

open access: yesAdvanced Engineering Materials, EarlyView.
The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi   +3 more
wiley   +1 more source

Effects of Stimulus and Recording Parameters on the Air Conduction Ocular Vestibular Evoked Myogenic Potential

open access: yes, 2011
Background: Vestibular evoked myogenic potentials (VEMPs) have been recorded from the sternocleidomastoid muscle (cervical VEMP or cVEMP) and more recently from the eye muscles (ocular VEMP or oVEMP) in response to air conduction and bone conduction ...
Owen D. Murnane   +7 more
core   +1 more source

Maximum output value (dB HL) for air and bone conduction across frequencies using an external sound card.

open access: yes, 2023
Maximum output value (dB HL) for air and bone conduction across frequencies using an external sound card.
Vidya Ramkumar (4901008)   +1 more
core   +1 more source

The Effect of Photovoltaic Panels on the Rooftop Temperature in the EnergyPlus Simulation Environment

open access: yesInternational Journal of Photoenergy, 2016
In this paper, the effects that photovoltaic (PV) panels have on the rooftop temperature in the EnergyPlus simulation environment were investigated for the following cases: with and without PV panels, with and without exposure to sunlight, and using roof
Changhai Peng, Jianqiang Yang
doaj   +1 more source

Hearing loss assessment in primary and secondary acquired cholesteatoma,

open access: yesBrazilian Journal of Otorhinolaryngology, 2015
INTRODUCTION: Acquired middle ear cholesteatoma can be classified as primary or secondary. Although both can result in hearing loss, it is still controversial whether there is an association between the type of cholesteatoma and the degree of hearing ...
Julia Maria Olsen   +3 more
doaj   +1 more source

Planar Solid‐State Nanopores Toward Scalable Nanofluidic Integration Based on CMOS Technology

open access: yesAdvanced Engineering Materials, EarlyView.
We present a scalable silicon‐based fabrication strategy for planar solid‐state nanopores to enable their integration with complex nanofluidic systems. Prototype devices demonstrate normal voltage‐current characteristics, good noise performance, and appreciable streaming currents. Our CMOS‐compatible fabrication process offers precise geometric control
Ngan Hoang Pham   +7 more
wiley   +1 more source

New Correlations for the Air-Side Heat Transfer Coefficient of Microchannel Heat Exchangers Under Quasi-Steady State Frosting Operating Conditions

open access: yes, 2012
This study experimentally investigated the frost growth on louvered folded fins in outdoor microchannel heat exchangers used in air-source heat pump systems.
Cremaschi, Lorenzo   +2 more
core  

Validity of endoscopic ossiculoplasty immediately after its introduction for ossicular chain disruption

open access: yesBMC Surgery
Background Transcanal endoscopic ear surgery (TEES) reportedly requires a long learning curve and may be associated with more complications and longer operative times than microscopic ear surgery (MES).
Atsushi Fukuda   +5 more
doaj   +1 more source

On the Lightweight Potential of Laser Additive Manufactured NiTi Triply Periodic Minimal Sheet Lattices

open access: yesAdvanced Engineering Materials, EarlyView.
This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo   +3 more
wiley   +1 more source

Electrochemical Evaluation of Compressed Selective Laser Melted AlSi7Mg and AlSi10Mg Alloys in Chloride Environment

open access: yesAdvanced Engineering Materials, EarlyView.
The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin   +2 more
wiley   +1 more source

Home - About - Disclaimer - Privacy