Results 111 to 120 of about 1,266 (172)

Modelling of tool life by response surface methodology in hard milling of Aisi D2 tool steel

, 2007
This paper presents a study of the development of a tool life model in end milling of hardened steel AISI D2 using PVD TiAlN coated carbide cutting tool. The hardness of AISI D2 tool lies within the range of 56-58 HRC.
Lajis, Mohd Amri, Karim, A.N. Mustafizul, Khalid, A. K. H., Amin, A. K. M. Nurul   +3 more
core  

Optimization of Punch Shaft Design for Reduced Punching Force and Enhanced Tool Life in S500MC Steel Sheet Forming. [PDF]

Materials (Basel)
Zeidi A, Elleuch K, Atapek ŞH, Konieczny J, Labisz K, Ćwiek J.   +5 more
europepmc   +1 more source

Author Correction: Performance enhancement of electrochemical discharge micromachining of borosilicate glass using nitrogen gas assistance. [PDF]

Sci Rep
Tamilperuvalathan S, Varadharaju V, Rajamohan S, Balasubramanian D, Kale U, Kilikevičius A.   +5 more
europepmc   +1 more source

Research on Friction Welded Connections of B500SP Reinforcement Bars with 1.4301 (AISI 304) and 1.4021 (AISI 420) Stainless Steel Bars. [PDF]

Materials (Basel)
Michałek J, Krawczyk R.
europepmc   +1 more source

The effects of boriding on kinetic, microstructure and corrosive behavior of Ramor 500 and Ramor 550 steels. [PDF]

Sci Rep
Tan HO.
europepmc   +1 more source

Characterization of AISI 304 stainless steel based on laser cutting process optimization. [PDF]

Sci Rep
Ali AS, Abdelmonem T, Elsoeudy R, Mohsen MA, Elzayady N.   +4 more
europepmc   +1 more source

A review of the corrosion and wear resistance mechanisms of gas nitriding on steel. [PDF]

iScience
Li J, Shao H, Lu K.
europepmc   +1 more source

Machining Accurate Deep Curved Forms on Tungsten Carbide-Cobalt (WC-Co) Eliminating Tool Wear in the Electrical Discharge Turning Operation. [PDF]

Micromachines (Basel)
Hadad M, Soleymani M, Alinaghizadeh A.
europepmc   +1 more source

Geometric influence and multi-objective optimization of WEDM for hardened tool steels using ANN and NSGA-II. [PDF]

Sci Rep
Sana M, Asad M, Khan A, Farooq MU, Hassan S, Anwar S.   +5 more
europepmc   +1 more source

Tool Wear Effect on Machinability and Surface Integrity in MQL and Cryogenic Hard Turning of AISI 4340. [PDF]

Materials (Basel)
Jouini N, Yaqoob S, Ghani JA, Mehrez S.
europepmc   +1 more source