Results 251 to 260 of about 195,722 (305)
Some of the next articles are maybe not open access.

Effective fracture toughness in Al2O3–Al2O3/ZrO2 laminates

Journal of the European Ceramic Society, 2007
During the processing of laminar ceramics, biaxial residual stresses can arise due to the thermal mismatch between different layers. For ceramic multilayers, the beneficial consequences of compressive stresses at the surface are well known: increase in strength, apparent toughness and reliability. Nevertheless, the resulting tensile stresses may induce
T Lube, J Pascual, F Chalvet, G De Portu
openaire   +2 more sources

Sulfuration of Pt/Al2O3, Pt−Re/Al2O3 and Pt−Ir/Al2O3 catalysts

Reaction Kinetics and Catalysis Letters, 1982
Three reforming catalysts Pt/Al2O3, Pt−Ir/Al2O3 and Pt−Re/Al2O3 have been sulfurated by H2S and tested by their activities in benzene hydrogenation. By treatment at 500°C under hydrogen flow only a part of the initial activity of the non-sulfurated catalyst is retained. So only a part of the adsorbed sulfur is easily removed in these conditions.
C. Apesteguia, J. Barbier
openaire   +1 more source

Microstructural study of the κ-Al2O3 → α-Al2O3 transformation in CVD κ-Al2O3

Surface and Coatings Technology, 1992
The microstructural variations occurring during the κ → α transformation in CVD κ-Al2O3 coatings subjected to isothermal heat treatments have been investigated. The microstructures developed in the partly transformed κ-Al2O3 layer (32% α-Al2O3) and fully transformed κ-Al2O3 layer (100% α-Al2O3) were studied and compared with as-deposited κ-Al2O3 (100 ...
J. Skogsmo, M. Halvarsson, S. Vuorinen
openaire   +1 more source

Kinetic study of glycerol hydrodeoxygenation on Al2O3 and NiMo2C/Al2O3 catalysts

Fuel, 2022
A kinetic study of glycerol hydrodeoxygenation (HDO) on NiMo2C/Al2O3 and Al2O3, prepared by sol-gel technique, was carried out in a batch reactor, from 250 °C to 285 °C, at high glycerol concentration (95 wt%). Structural and surface properties of the catalysts were determined by XRD, nitrogen physissorption, TEM and NH3-TPD.
Rafael Belo Duarte   +3 more
openaire   +1 more source

Sulfurization of Pt/Al2O3−Cl catalysts. IV. Adsorption sites of H2S on Al2O3, Al2O3−Cl and Pt/Al2O3−Cl

Reaction Kinetics and Catalysis Letters, 1982
Chemisorption of H2S on Al2O3, Al2O3−Cl and Pt/Al2O3−Cl has been studied by gravimetry and IR spectroscopy. The influence of the amount of Cl on the H2S adsorption equilibrium value and the nature of the adsorption sites at low and high coverages are discussed.
C. R. Apesteguía   +4 more
openaire   +1 more source

Differences in the catalytic properties of Al2O3 and Pt/Al2O3

Reaction Kinetics and Catalysis Letters, 1983
The different behaviors of Al2O3 and Pt−Al2O3 for typical hydrocarbon reactions were studied at 500°C and atmospheric pressure. Pt−Al2O3 reached higher total conversion levels, was more easily deactivated and produced more coke deposition than Al2O3 due to reactions catalyzed by Pt (hydrogenolysis and dehydrogenation).
J. M. Parera   +3 more
openaire   +1 more source

Adsorption and spillover of hydrogen on Al2O3 and Pt/Al2O3

Applied Catalysis, 1987
Abstract Hydrogen adsorption on alumina, Pt/Al 2 O 3 -Cl, and their mixtures at 500°C and under atmospheric pressure was studied using a volumetric technique. Alumina with and without chlorine adsorbed 0.054 cm 3 STP g −1 showing that chloride ions do not affect the adsorption.
J.C. Musso, J.M. Parera
openaire   +1 more source

Mechanisms of hydrodenitrogenation of alkylamines and hydrodesulfurization of alkanethiols on NiMo/Al2O3, CoMo/Al2O3, and Mo/Al2O3

Journal of Catalysis, 2005
Abstract The simultaneous hydrodenitrogenation (HDN) of alkylamines and hydrodesulfurization (HDS) of alkanethiols, with the NH2 and SH groups attached to primary, secondary, and tertiary carbon atoms, were studied at 270–320 °C and 3 MPa over sulfided NiMo/Al2O3, CoMo/Al2O3, and Mo/Al2O3 catalysts.
Y ZHAO, R PRINS
openaire   +1 more source

Impact Testing of Al2O3 and SiCw/Al2O3 Ceramics

1994
A bar impact test procedure was used to study spallation of Al2O3 bars and dynamic fracture of Al2O3 and SiCw/Al2O3 bars. Fractography analysis of the spalled surface showed extensive intergranular fracture (90 to 95% area). Dynamic fracture studies of precracked Al2O3 and SiCw/Al2O3 bars showed that the dynamic initiation fracture toughness, KId, and ...
LR Deobald, AS Kobayashi
openaire   +1 more source

Effects of copper and Al2O3 particles on characteristics of Cu–Al2O3 composites

Materials & Design, 2010
Abstract High-energy milling was used for production of Cu–Al 2 O 3 composites. The inert gas-atomized prealloyed copper powder containing 2 wt.%Al and the mixture of the different sized electrolytic copper powders with 4 wt.% commercial Al 2 O 3 powders served as starting materials.
Rajković, Višeslava M.   +2 more
openaire   +2 more sources

Home - About - Disclaimer - Privacy