Results 41 to 50 of about 195,722 (305)

Studies of processes of the precursor formation for production of CuAl2O4 nanoceramics at the effect of double laser pulses on AD1 and M2 alloys in the air atmosphere

open access: yesФизико-химические аспекты изучения кластеров, наноструктур и наноматериалов, 2021
A study of formation of mixed Al nanopowders, copper and aluminum oxides, and precursors for production of CuAlO2 and CuAl2O4 nanoceramics under the influence of double laser pulses with energy of 53 mJ and the interpulse interval of 10 microseconds on a
Maxim N. Kovalenko   +5 more
doaj   +1 more source

Fabrication of a High Wear Resistance AA7075/AL2O3 Composites Via Liquid Metallurgy Process

open access: yesInternational Journal of Applied Mechanics and Engineering, 2022
In the present study, AA7075/Al2O3 composites have been fabricated via liquid metallurgy process. AA7075 alloy and Al2O3 particles were taken as the base matrix and reinforcements, respectively. Then, contents of 3 and 6 wt.
R. Sivaraman   +5 more
doaj   +1 more source

Effects of ZrO2 and Al2O3 Addition on the Physical Properties of Cu-Mo-Cr Alloy by Liquid Phase Sintering [PDF]

open access: yesArchives of Metallurgy and Materials, 2021
In this study, the effect of the addition of ZrO2 and Al2O3 ceramic powders to Cu-Mo-Cr alloy was studied by examining the physical properties of the composite material. The ceramic additives were selected based on the thermodynamic stability calculation
Yeong-Woo Cho   +9 more
doaj   +1 more source

Hardness and friction behavior of bulk CoAl2O4 and Co–Al2O3 composite layers formed during Spark Plasma Sintering of CoAl2O4 powders [PDF]

open access: yes, 2012
Materials made up of a Co–Al2O3 composite coating over a CoAl2O4 core are prepared during Spark Plasma Sintering of CoAl2O4 powders. The Co particles are precipitated because of a combination of high temperature and low O2 partial pressure.
Estournès, Claude   +5 more
core   +1 more source

Atomic layer deposited films of Al2O3 on fluorine-doped tin oxide electrodes: stability and barrier properties

open access: yesBeilstein Journal of Nanotechnology, 2021
Al2O3 layers were deposited onto electrodes by atomic layer deposition. Solubility and electron-transport blocking were tested. Films deposited onto fluorine-doped tin oxide (FTO, F:SnO2/glass) substrates blocked electron transfer to redox couples ...
Hana Krýsová   +5 more
doaj   +1 more source

Experimental studies in plate heat exchanger using therminol-55/Al2O3 & glycerol/Al2O3 nanofluids [PDF]

open access: yesChemical Industry and Chemical Engineering Quarterly
The experiment aimed to compare the heat transfer performance of two base fluids, Therminol-55 and glycerol, both mixed with aluminum oxide nanoparticles.
Srinivasan Periasamy Manikandan   +1 more
doaj   +1 more source

Solubility of Al2O3 in the Na2O-Al2O3-H2O-CH3OH System at (30 and 60) degrees C

open access: yes, 2009
To realize the objective of high alumina yield and a high molar Na2O/Al2O3 ratio in caustic solutions for Bayer plants, this paper presents the solubility of Al2O3 in methanol-water solvent mixtures with a fixed mass ratio of methanol to water 1:1 at (30
Zhang, Ying   +10 more
core   +1 more source

Enhancement of Cobalt Catalyst performance and Stability in Fischer-Tropsch Synthesis Using Graphene Nanosheets as Catalyst Support [PDF]

open access: yesشیمی کاربردی روز, 2016
Graphene nano sheets (GNS) supported cobalt catalyst, is introduced for Fischer-Tropsch synthesis (FTS). The catalyst was prepared using wet impregnation method with cobalt loading of 15.0 wt%.
Seyedeh Somayeh Taghavi   +2 more
doaj   +1 more source

Síntesis y caracterización estructural del compuesto de refuerzo de Ti+Ni3Al+Al2O3 a base de Fe producido por aleación mecánica

open access: yesRevista de Metalurgia, 2020
La mezcla de polvo de Ti+Ni3Al+Al2O3 a base de Fe se alea mecánicamente en un molino de bolas Spex. Los compuestos con adición de Ti+Ni3Al+Al2O3 a base de Fe se produjeron a una temperatura de sinterización de 1000 °C durante un tiempo de 1 h.
Tanju Teker, S. Osman Yilmaz
doaj   +1 more source

Al2O3-based binders for corrosion resistance optimization of Al2O3–MgAl2O4 and Al2O3–MgO refractory castables

open access: yesCeramics International, 2015
Abstract This work addresses the main aspects related to the use of alternative binders [hydratable (HA) or colloidal alumina (ColAlu)] in castables containing different spinel sources (pre-formed or in situ generated), in order to point out: (i) the features that control the corrosion behavior of these materials, and (ii) the key factors to better
Tomba Martinez, Analia Gladys   +3 more
openaire   +2 more sources

Home - About - Disclaimer - Privacy