Results 91 to 100 of about 4,367,826 (311)

A note about almost uniform convergence on D-poset of intuitionistic fuzzy sets [PDF]

open access: yesNotes on IFS
The aim of this contribution is studying the almost uniform convergence on D-poset of intuitionistic fuzzy sets. We prove the connection between almost everywhere convergence of random variables in Kolmogorov probability space and almost uniform ...
Katarína Čunderlíková
doaj   +1 more source

Investigation of Laser Ablation and Brush Pre‐Treatments for AlCu Cold Roll Bonding in Oxygen‐Free Conditions

open access: yesAdvanced Engineering Materials, EarlyView.
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti   +11 more
wiley   +1 more source

Maximal multilinear operators

open access: yes, 2005
We establish multilinear $L^p$ bounds for a class of maximal multilinear averages of functions on one variable, reproving and generalizing the bilinear maximal function bounds of Lacey.
Demeter, Ciprian   +2 more
core   +1 more source

Characterization of Nitinol Produced by Laser Powder Bed Fusion for Mechanical Metamaterial Applications

open access: yesAdvanced Engineering Materials, EarlyView.
Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek   +5 more
wiley   +1 more source

Strong and Weak Convergence for Asymptotically Almost Negatively Associated Random Variables

open access: yesDiscrete Dynamics in Nature and Society, 2013
The strong law of large numbers for sequences of asymptotically almost negatively associated (AANA, in short) random variables is obtained, which generalizes and improves the corresponding one of Bai and Cheng (2000) for independent and identically ...
Aiting Shen, Ranchao Wu
doaj   +1 more source

Almost convergence and nonlinear ergodic theorems

open access: yes, 1978
The first ergodic theorems for nonlinear nonexpansive mappings and semigroups in Hilbert space were established by Baillon [I, 2, 31 and by Baillon and BrCzis [4].
S. Reich
semanticscholar   +1 more source

Thermomechanical Fatigue and Creep–Fatigue Interaction of Inconel 718 Additively Manufactured by Laser Beam Powder Bed Fusion

open access: yesAdvanced Engineering Materials, EarlyView.
Thermomechanical fatigue tests of laser beam powder bed fusion (PBF‐LB) Inconel 718 show that the additively manufactured material reaches almost the lifetimes of conventionally‐rolled material under no‐dwell conditions. Introducing dwell times at the maximum temperature markedly reduces the lifetimes due to pronounced grain boundary sliding associated
Stefan Guth   +6 more
wiley   +1 more source

Composition‐Tuned Enhancement of the Anomalous Nernst Effect in FeCo–Pt Thin Films on Rigid and Flexible Substrates

open access: yesAdvanced Engineering Materials, EarlyView.
Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi   +2 more
wiley   +1 more source

Al–Cu Composite Casting of Laser‐Deoxidized Copper: Bonding, Interfacial Chemistry, and Thermal Conductivity

open access: yesAdvanced Engineering Materials, EarlyView.
This study investigates laser‐based oxide removal of Cu inserts in oxygen‐free conditions and examines long‐term oxidation kinetics and surface chemistry under different atmospheres via X‐ray photoelectron spectroscopy. Al–Cu compound casting with differently oxidized surfaces is performed, and intermetallic phase formation, morphology, and thermal ...
Timon Steinhoff   +9 more
wiley   +1 more source

Evaluating Energy Absorption Performance of Filled Lattice Structures

open access: yesAdvanced Engineering Materials, EarlyView.
Maximum stress must be considered to robustly evaluate energy absorber designs. This approach was applied to compare all types of absorbers in a single Ashby diagram and determine the utility of filling lattice voids with a second material. High‐performance fillers can improve the performance of lattices that are limited by buckling or catastrophic ...
Christian Bonney   +2 more
wiley   +1 more source

Home - About - Disclaimer - Privacy