Results 11 to 20 of about 547,564 (264)
Direct selective laser sintering of aluminium alloy powders [PDF]
, 2008 The SLS/SLM of aluminium powder had been investigated by studying the effect of powder properties and laser processing parameters on the microstructures and properties of both single layer and multiple layer builds. On the basis of experimental evidence,
Olakanmi, Eyitayo Olatunde
core +7 more sources
Effect of Al addition on microstructure of AZ91D [PDF]
, 2014 Casting is a net shape or near net shape forming process so work-hardening will not be applicable for improving properties of magnesium cast alloys.
Joshi, U, Babu, NH
core +7 more sources
Effects of hydrogen in an aluminium-magnesium-silicon alloy during the production of extrusion ingots [PDF]
, 1995 This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.Hydrogen causes defects, for which aluminiurn alloy products are rejected.
Al-Rais, Masood
core +7 more sources
Journal of Materials Research and Technology, 2020 A very effective approach is proposed here to increase the high-temperature fatigue life of an Al-Si piston alloy. Compared with traditional T6 heat treatment, the high-temperature fatigue life can be improved by three times of magnitude with thermal ...
F. Xia +7 more
doaj +1 more source
Instability of in situ TiC particles in an Al-12Si alloy
Journal of Materials Research and Technology, 2020 This paper studied the evolution of in situ TiC particles in an Al-12Si alloy and the effect of Si on their stability. The samples were observed with scanning electron microscopy, and the phase analysis was performed by energy dispersive spectroscopy, X ...
F. Xia +6 more
doaj +1 more source
Prediction of the residual stress after quenching of 6061 aluminium alloy plates by using mathematical modelling [PDF]
ITM Web of Conferences, 2020 The purpose of this article is to better understand the behavior of the residual stresses in aluminium alloy plates by using mathematical modelling. Quenching of aluminium alloy plates causes an uneven temperature variation in aluminum alloy plates, and ...
Petre Marin +3 more
doaj +1 more source
Reviews on Advanced Materials Science, 2022 The durability of concrete structures is often reduced owing to the corrosion of reinforcement in an aggressive environment. Ordinary reinforcement methods, such as wrapping section steel or steel plate, are also vulnerable to corrosion.
Luo Daming, Li Fan, Xing Guohua
doaj +1 more source
Applied Sciences, 2018 In the present paper, the microstructures of three kinds of in-situ reinforcements Al-Ti-C, Al-Ti-B, and Al-Ti-B-C-Ce were deeply investigated using a combination of scanning electron microscopy, X-ray diffraction spectroscopy, and transmission electron ...
Lusha Tian +7 more
doaj +1 more source
Physical Modelling of the Production of an Alloy Vapour Source for the Synthesis of Dielectric Material [PDF]
Archives of Metallurgy and Materials, 2020 The paper reports the results of a physical modelling study of the production of a hypereutectic aluminium alloy to be used for making an alloy vapour source for operation in the magnetron. Within the study, targets from a hypereutectic aluminium-silicon
M. Nadolski +3 more
doaj +1 more source
TEM characterisation of near surface deformation resulting from lubricated sliding wear of aluminium alloy and composites [PDF]
, 2007 Aluminium alloy composites have been extensively investigated for use in tribo-contact applications, however little detailed literature exists on the sub-surface microstructural evolution as a result of lubricated sliding wear.
Rainforth, W.M. +7 more
core +1 more source