Results 11 to 20 of about 12,032 (268)
Mode Locking in a Free-Electron Laser Amplifier [PDF]
Accepted for publication in Physical Review ...
Thompson, N R, McNeil, B W J
openaire +5 more sources
A new active-only sinusoidal oscillator is presented. The oscillator circuit uses two internally compensated operational amplifiers, two plus-type second-generation current conveyors and three operational transconductance amplifiers. The proposed circuit
Muhammad Taher Abuelmaatti
doaj +1 more source
The paper presents a novel solution of a fully-differential 1+α fractional-order filter. The filter can provide low-pass, high-pass, band-pass and band-stop transfer functions without a necessity of a circuitry change (filter is electronically ...
Lukas Langhammer +3 more
doaj +1 more source
Design of Higher-Order Fractional Filters With Fully Controllable Frequency Characteristics
Higher-order fractional filters with fully controllable frequency characteristics are realized in this work, after fitting the filter’s magnitude response data using a minimum-phase state-space model.
Julia Nako +3 more
doaj +1 more source
M-Polar Fuzzy Graphs and Deep Learning for the Design of Analog Amplifiers
The design of analog circuits is a complex and repetitive process aimed at finding the best design variant. It is characterized by uncertainty and multivariate approaches.
Malinka Ivanova, Mariana Durcheva
doaj +1 more source
Chaos in a Non-Autonomous Inductorless Active-RC Circuit
Chaotic performance of a simple inductorless active-RC non-autonomous electronic circuit is reported. The circuit uses two operational amplifiers, an operational transconductance amplifier, a diode, two resistors, and one capacitor only.
Muhammad Taher Abuelma'atti +1 more
doaj +1 more source
Design and Simulation of 1.5GHz Amplifier Utilizing the BFR92A and Transmission Lines [PDF]
The key factor of providing good performance for any electronic device is by eliminating unwanted reflections those lead to waste energy and, therefore, affect circuit stability.
Ahmed W. Al-Saffar
doaj +1 more source
Energy Harvesting on AB-Class Power Amplifier Applying Thermoelectric Generators in Push–Pull Mode
Amplifiers are among the most commonly used circuits in electronics, performing a variety of functions in a wide range of electronic systems. Depending on the application and design, each amplifier generates waste heat.
Ivan Škalic +2 more
doaj +1 more source
Characteristic Test Of Transistor Based Multisim Software
--The purpose of this study is to determine the characteristics of the transistor before it is used in the circuit. Transistors are semiconductor devices used as amplifiers, as circuit breakers and connectors (switching), voltage stabilization, signal ...
Muhammad Ruswandi Djalal, Herman HR
doaj +1 more source
A simple procedure for approximating the input-output characteristic of non-linear electronic circuits is presented. Using this procedure, closed-form analytical expressions, in terms of the ordinary Bessel functions, are obtained for the output spectra ...
Muhammad Taher Abuelma'atti
doaj +1 more source

