Results 71 to 80 of about 23,719 (291)
Advanced Engineering Materials, EarlyView.Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi +2 more
wiley +1 more source
Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys
Advanced Engineering Materials, EarlyView.This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa +9 more
wiley +1 more source
Geotechnical problems in buildings set on alluvial deposits in flood plains and peneplains
Revista Ingenio, 2017 This article presents the stratigraphic characterization of the subsoil in the “Eden Premier” subdivision located in Tabasco, Mexico, determined from 8 mixed soundings carried out in the study area, which is made up of heterogeneous alluvial deposits ...
Oscar Andrés Cuanalo Campos +3 more
doaj +1 more source
Modified Equivalent Load Method for Welding Distortion Analysis
Journal of Marine Science and Engineering, 2020 In this study, modified equivalent load method for welding distortion analysis is suggested to improve its accuracy. To avoid the excessive computational time for welding distortion analysis of large welded structures, shell element-based elastic ...
Jaemin Lee, Hyun Chung
doaj +1 more source
, 2020 In this paper the influence of tack welds distribution and welding sequence on angular distortion of the Tungsten Inert Gas (TIG) welded joint was tested. Additionally, the effect of welding current on angular distortion was assessed.
Tomków, Jacek +2 more
core +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates how optimizing laser power, scanning speed, and hatching distance in laser powder bed fusion can boost the productivity of Inconel 718 manufacturing by up to 29% while maintaining mechanical integrity. The work delivers a validated process window and cost–time analysis, offering industry‐ready guidelines for efficient additive ...
Amir Behjat +7 more
wiley +1 more source
Sensors, 2020 Lens distortion is closely related to the spatial position of depth of field (DoF), especially in close-range photography. The accurate characterization and precise calibration of DoF-dependent distortion are very important to improve the accuracy of ...
Xiao Li +4 more
doaj +1 more source
, 2022 A novel square equal-area map projection is proposed. The projection combines closed-form forward and inverse solutions with relatively low angular distortion and minimal cusps, a combination of properties not manifested by any previously published ...
Petroff, Matthew A.
core +1 more source
Advanced Engineering Materials, EarlyView.New features on yttria‐stabilized zirconia after exposure at 1500°C: Newly discovered pyramidal structures on an old material. After exposure at 1550°C on the cross section of YSZ new features, namely pyramidal structures are discovered. These structures grow with time, increase in numbers, appear as singularities, are often arranged in strings, and ...
Doris Sebold +2 more
wiley +1 more source
Influence of welding parameters on angular distortion of weld
, 2015 The aim of this thesis is to qualify influence of welding parameters on angular distortion of weld. This thesis is divided into two parts - theoretical part and experimental part. The theoretical part is focused on solving causes of origin of tension and
Crla, Tobiáš
core +1 more source