Results 121 to 130 of about 134,165 (299)
Advanced Engineering Materials, EarlyView.Dislocation cutting of γ′ precipitates in Ni‐based superalloys is investigated by linking atomistic simulations with discrete dislocation dynamics. The critical cutting stress is shown to be governed by the antiphase boundary energy, while line tension effects promote edge‐preferred cutting.
Frédéric Houllé +9 more
wiley +1 more source
A Method for Calculating the Cohesive Force of Uniform Cohesion Soil
工程科学与技术, 2019 Cohesive force is an important mechanical parameter of cohesive soil, and the density and void ratio of soil are important factors affecting its cohesion, but the cohesion force of cohesive soil is difficult to estimate, while its density and void ratio ...
Xianghui LI +4 more
doaj
Beilstein Journal of Nanotechnology, 2015 There has been much interest in the past two decades to produce experimental force profiles characteristic of the interaction between nanoscale objects or a nanoscale object and a plane.
Annalisa Calò +3 more
doaj +1 more source
Feasibility of Nitrogen as a Carrier Gas for Inconel Cold Spray in Hydropower Application
Advanced Engineering Materials, EarlyView.N2, despite being nearly two orders of magnitude cheaper than He, is a feasible carrier gas for cold spray Inconel coatings in hydropower repair applications when higher gas temperature and pressure are used. Reducing powder size significantly improved cavitation resistance, while the addition of fine chromium carbide particles further enhanced erosion
Tianhao Wang +4 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Molecular dynamics is used to investigate structure refinement during severe plastic deformation. The results show similitude with experimental data. Molecular dynamics simulations of severe plastic deformation of monocrystalline and polycrystalline samples by multiaxial compression of aluminum are carried out.
Roberto B. Figueiredo
wiley +1 more source
Brachistochrones For Attractive Logarithmic Potential [PDF]
, 1999 Brachistochrones are constructed for attractive central force, with logarithmic potential.
Tee, Garry J.
core
Advanced Engineering Materials, EarlyView.Grain boundary triple junctions are an essential ingredient of the microstructure of polycrystalline materials. In this study, a triple junction is observed using atomic‐resolution scanning transmission electron microscopy and characterized. Computer simulations reveal that the junction has a dislocation character that is determined by the joining ...
Tobias Brink +4 more
wiley +1 more source
Probing attractive forces at the nanoscale using higher-harmonic dynamic force microscopy [PDF]
, 2005 We systematically investigate higher harmonics in the vibration spectrum of scanning force microscope cantilevers operating in the attractive regime.
Raman, A. +3 more
core +1 more source
Advanced Engineering Materials, EarlyView.Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal +3 more
wiley +1 more source
Design and Analysis of Compression–Torsion Coupling Metamaterials Using the Golden Section Method
Advanced Engineering Materials, EarlyView.A novel compression–torsion metamaterial is engineered using inclined rods and symmetry breaking. To optimize its torsional performance, the golden section method is employed. The mechanical response of the metamaterial is validated through both numerical analysis and experimental validation.
Amirhossein Hassani, Sara Bagherifard
wiley +1 more source