Results 111 to 120 of about 2,506 (247)
steel research international, EarlyView.Prebending of 304L/Q345R cladded plates significantly alters the subsequent weld thermal cycle and modifies the local interfacial microstructure. Combined electron backscatter diffraction (EBSD) and microscopy analysis demonstrates that deformation twinning, martensitic transformation, and defect initiation are concentrated at the trimaterial junction,
Ali Fahem +2 more
wiley +1 more source
steel research international, EarlyView.A double intercritical annealing strategy is proposed to tailor the multiphase microstructure and mechanical response of a medium‐Mn steel. The treatment produces an ultrafine mixture of ferrite, martensite and multiple austenite populations with graded thermal and mechanical stability, formed through austenite reversion and controlled retransformation.
Mattia Franceschi +3 more
wiley +1 more source
steel research international, EarlyView.This work uses high‐temperature dilatometry to examine how the tramp elements Cu, Ni, and Sn affect the deformability of non‐metallic inclusions and matrix in quench‐and‐temper steel. Mg‐bearing inclusions deform less than Mg‐free ones. Copper lowers formability. Nickel increases deformability.
Julian Cejka +3 more
wiley +1 more source
On the Stabilization of the Austenite for the Martensite Transformation
Journal of the Japan Institute of Metals, 1952 Masazô Okamoto, Ryôhei Odaka
openaire +2 more sources
steel research international, EarlyView.Paint baking of resistance spot welded joints of 2.0 GPa warm‐stamped medium‐Mn steel activates low‐temperature tempering, forming fine cementite in the fusion zone and enhancing toughness. Crack propagation resistance increases, shifting the failure mode from partial interfacial to complete pullout, with peak load and energy absorption rising ...
Sunusi Marwana Manladan +8 more
wiley +1 more source
steel research international, EarlyView.An accurate moving boundary model for volume diffusion containing boundary conditions from trans‐interface diffusion (TID) simulates the austenite growth during cooling. TID of Cr, Mo, N and Ni enhance growth kinetics. Without TID, compositions of the interface region change, decreasing the driving force for growth and finally causing numerical ...
A. Salwén +3 more
wiley +1 more source
Stabilization of austenitic stainless steel
Journal of Research of the National Bureau of Standards, 1948 Samuel J. Rosenberg, John H. Darr
openaire +1 more source
steel research international, EarlyView.This review explains how impurities from recycled scrap affect steel production and performance. Even small amounts (far below 1%) of these impurities can change how steel behaves during fabrication but also affect the properties of the end product. With better understanding and targeted countermeasures, these challenges can be managed, enabling wider ...
Oleksandr Glushko, Ronald Schnitzer
wiley +1 more source
Austenite stability in TRIP steels studied by synchrotron radiation
, 2014 Radiation Science and ...
openaire +3 more sources
steel research international, EarlyView.High Nb (2.4 wt.%) addition to Maraging 300 steel drives lattice distortion and nanoscale Nb–Mo‐rich precipitation, confirmed by energy‐dispersive X‐ray spectroscopy mapping (Mo ~5.4 wt.%, Nb ~2.5 wt.%). Nanoindentation reveals strong matrix hardening (H >4.8 GPa) at 480°C aging, while 560°C induces ~1.92 vol.% reverted austenite, enabling tunable ...
Laylla Sharon B. Peixoto +9 more
wiley +1 more source