Results 71 to 80 of about 3,765,299 (160)
Investigation of masking concepts for influencing the austenitization process during press hardening [PDF]
, 2018 One possibility to adjust tailored properties in hot stamping is the application of a masking concept to prevent a complete austenitization. In this study different concepts were investigated in order to use them as a suitable masking. A simulation model
Behrens, Bernd-Arno +6 more
core +1 more source
Effect of Different Surface Treatments on Resistance to Abrasive Wear of AISI 4140 Steel
steel research international, EarlyView.This study investigates how different surface treatments affect resistance to abrasive wear of AISI 4140 Steel. The wear rate was significantly higher in samples subjected to conventional treatments than in samples coated using the HVOF process, demonstrating the superior efficiency of coatings applied by thermal spraying in mitigating abrasive wear ...
Everton Freitas de Oliveira +3 more
wiley +1 more source
The influence of full and partial austenitization temperatures on the quench and partition heat treatment process for an advanced high strength steel [PDF]
, 2018 The effect of full and partial austenitization on the microstructural evolution of a medium carbon steel with 2.2 mass %Si was studied during the quench and partitioning heat treatment process.
Mostert, Roelf Johannes +3 more
core +1 more source
Nuclear Materials and Energy, 2018 Among the options currently taken into account for the realization of the first DEMO reactor there are the “helium-cooled” and the “dual coolant” breeding blanket.
C. Cristalli +5 more
doaj +1 more source
, 2022 The present study was performed to investigate the influences of short-time austenitization on mechanical properties and transformation-induced plasticity (TRIP) in austempered ductile iron.
Nalcaci, Burak +4 more
core +1 more source
, 2011 The use of martensitic stainless steels is commonly due to high mechanical properties requirements. To obtain these high values from the industrial material (whose microstructure consists in ferrite and M23C6carbides), a suitable heat treatment ...
Thomas Fröhlich +2 more
core +1 more source
MetalsA modified carbide-free bainite (CFB) steel has been developed, building on existing alloys for compatibility with commercial continuous annealing lines (CALs), featuring a low austenitization temperature and short overaging time.
Bahareh Mobedpour +2 more
doaj +1 more source
Microstructure and mechanical properties of ADI depending on austenitization methods and parameters [PDF]
, 2012 Ductile iron was quenched using two-variant isothermal transformation. The first treatment variant consisted of one-phase austenitization at a temperature t = 830, 860 or 900 C, cooling down to an isothermal transformation temperature of 300 or 400 C and
Szykowny, T., Giętka, T.
core
, 2019 Inclusion-induced acicular ferrite (AF) nucleation has been used for microstructure refinement in steel. Austenitization conditions have a significant influence on AF nucleation ability.
Xin Wang +4 more
core +1 more source
, 1998 In this study, the effect of double austenitization on microstructure and toughness of AISI M2 high speed steel was investigated. For double austenitization treatment, the specimens, which are hardened initially at 1220 degrees C and quenched in air ...
Ögel, Bilgehan +3 more
core +1 more source