Results 11 to 20 of about 1,996 (186)
Journal of Materials Research and Technology, 2021 The effects of isothermal and pre-transformation temperatures on the microstructure and mechanical properties of ultrafine bainitic steels are investigated and theoretically analyzed by using optical microscopy, scanning electron microscopy, transmission
Chengcong Huang +4 more
doaj +1 more source
Bainite transformation under the effect of large stress in a carbide-free bainite steel
Journal of Materials Research and Technology, 2023 The effects of large stress on bainite transformation and microstructure were investigated by dilatometry, SEM and EBSD. The results show that the effect of large stress on bainite transformation includes two parts: mechanical driving force and prior ...
Mingxing Zhou +5 more
doaj +1 more source
Proceedings of the Royal Society A: Mathematical, Physical and Engineering Sciences, 2009 An alloy system based on iron is described in which it has been possible to create a high density of interfaces by heat treatment alone. The resulting structure consists of a mixture of slender platelets of bainitic ferrite, just 20–40 nm in thickness, embedded in a matrix of carbon-enriched austenite.
openaire +1 more source
Bainite kinetic transformation of austempered AISI 6150 steel
Journal of Materials Research and Technology, 2020 This research studies the kinetic transformation and austempering temperature effect on the morphologies of bainite for AISI 6150 steel. A minimum of 10 different holding times for each austempering temperature were utilized.
Xue Han +6 more
doaj +1 more source
Journal of Materials Research and Technology, 2021 This work presents the effect of Ni content on the bainite morphology and in the mechanical properties of low-carbon special bar quality steels. Four steel ingots with the same base chemical composition, having only Ni content as their main difference ...
José Britti Bacalhau +1 more
doaj +1 more source
Metals, 2020 The transformation behavior and microstructural evolution during continuous cooling within the heat affected zone between the weld beads of a 2.25Cr-1Mo-0.25V all-weld metal and the corresponding 2.25Cr-1Mo-0.25V base metal were investigated by means of ...
Hannah Schönmaier +6 more
doaj +1 more source
Variant Pairing of Lath Bainite and Martensite in an Ultra-High-Strength Steel
Metals, 2022 The mixed structure of lath bainite and martensite was obtained by isothermal transformation tests at 698 K, 673 K and 623 K in ultra-high-strength steel. The interweaving mode of lath bainite and martensite was revealed by colored metallography and band
Meiying Li +3 more
doaj +1 more source
Transformation kinetics of carbide-free bainitic steels during isothermal holding above and below MS
Journal of Materials Research and Technology, 2020 The transformation kinetics of a low carbon bainitic steel was investigated using in situ confocal microscopy and dilatometry for isothermal treatments above and below the martensite start (MS) temperature.
Junyu Tian, Dr. +4 more
doaj +1 more source
Cailiao gongcheng, 2016 Coarse grain heat affected zone (HAZ) of F460 steel was simulated by a Gleeble 3800 thermo-mechanical simulator. The microstructure, critical event of the HAZ formed at various heat inputs (E) were characterized and determined by optical microscopy (OM ...
LI Jing +4 more
doaj +1 more source
Metals, 2022 The influence of austenitisation temperature and time on the martensitic and isothermal bainite transformation of 51CrV4 spring steel was analysed. Based on the analysis of dilatometric curves, the martensite start temperatures (MS) were determined at ...
Anže Bajželj, Jaka Burja
doaj +1 more source