Results 21 to 30 of about 2,307,569 (203)
Austempering and Bainitic Transformation Kinetics of AISI 52100
Journal of Materials Engineering and Performance, 2021 Abstract AISI 52100 is a high carbon alloy steel typically used in bearings. One hardening heat treatment method for AISI 52100 is austempering, in which the steel is heated to above austenitizing temperature, cooled to just above martensite starting (Ms) temperature in quench media (typically molten salt), held at that temperature until
Haoxing You +3 more
openaire +1 more source
Characterisation and Development of Nanostructured, Ultrahigh Strength, and Ductile Bainitic Steels [PDF]
, 2006 The purpose of the present work was to characterise and further develop a novel nanostructured type of bainitic steel. Three chemical compositions were considered with different concentrations of Al and Co.
Sherif MY, Sherif, Mohamed
core +2 more sources
Materials & Design, 2023 A novel in-situ scanning electron microscope (SEM) characterization technique for observing phase transformation is developed and its results studied and compared to well-founded experimental ex-situ methods as well as numerical modelling of bainite ...
O. Seppälä +6 more
doaj +1 more source
Thermodynamic analysis and strength-toughness research of nanobainite
工程科学学报, 2016 In view of slow phase transformation rate in high-carbon,silicon-rich and low-alloy bainite steel(nanostructured bainite steel),the effects of alloy elements on the overall kinetics of low temperature bainite phase transformation were analyzed by using ...
ZHI Chao +4 more
doaj +1 more source
Effect of Carbon Content on Bainite Transformation Kinetics and Microstructure of 4140/4150 Steels [PDF]
, 2019 4140 steel and 4150 steel are different only in their carbon content. A comparison between the kinetics and microstructure of the bainite transformation of both steels has been carried out under a wide range of isothermal temperatures, in which four ...
Qin, Hao +4 more
core +1 more source
Applied Sciences, 2022 Carbide-free bainitic (CFB) steels with a matrix of bainitic ferrite and thin layers of retained austenite, to reduce the manufacturing costs, usually do not contain alloying elements.
Behdad Garmeh +5 more
doaj +1 more source
A semi-physical α-β model on bainite transformation kinetics and carbon partitioning
, 2021 A semi-physical kinetic model with two adjustable parameters is proposed for prediction of the isothermal bainite transformation and carbon redistribution in steels.
Wei, Wen Wen +3 more
core +1 more source
An Alternative to Avrami Equation [PDF]
Materials Research, 2019 This paper proposes an alternative to the Avrami equation capable of describing whole transformation curves with significant fitting-correlations. The model bears physically meaningful parameters which permit considering the initial transformation ...
José Roberto Costa Guimarães +2 more
doaj +1 more source
Metals, 2021 In this work, the microstructural evolution during the dynamic transformation of austenite to bainite was directly observed by in-situ high energy synchrotron X-ray diffraction measurements during warm uniaxial compression performed at the P07 beamline ...
William Lemos Bevilaqua +6 more
doaj +1 more source
Journal of Materials Research and Technology, 2021 This work presents the effect of Ni content on the bainite morphology and in the mechanical properties of low-carbon special bar quality steels. Four steel ingots with the same base chemical composition, having only Ni content as their main difference ...
José Britti Bacalhau +1 more
doaj +1 more source