Results 111 to 120 of about 7,892,925 (256)
, 2010 This paper presents an efficient carbon nanotube (CNT) transistor modeling technique which is based on cubic spline approximation of the non-equilibrium mobile charge density.
Ashburn, Peter +3 more
core
Programmable Porosity in Polymers via Microfluidic Templating and 3D Printing
Small Methods, EarlyView.Fluid templating is a powerful way to produce porous polymers. Microfluidic technologies enable fine control over the dimension and packing of bubbles and droplets. Combined with additive manufacturing, microfluidic templating enables the creation of polymeric functionally graded porous materials in which both porosity and three‐dimensional geometry ...
Federico Serpe +3 more
wiley +1 more source
STUDY ON THE EFFECT OF OBLIQUE IMPACT ANGLE ON THE FAILURE CHARACTERISTICS OF ALUMINUM ALLOY SHEET
Jixie qiangdu, 2022 In order to study the failure mechanism of 6061-T651 aluminum alloy sheet under oblique impact, the impact experiments of a hemispherical projectile slanting into a single aluminum alloy sheet at different impact angles（0°, 15°, 30°, 45°） were carried ...
HU Jing, Lü YuHan
doaj
Experimental Tests and Numerical Simulations on the Ballistic Impact Response of a Highly Inhomogeneous Aluminium Foam. [PDF]
Materials (Basel), 2022 Brekken KA +4 more
europepmc +1 more source
steel research international, EarlyView.The high‐strain‐rate behavior of resistance spot‐welded DP800–DP1000 joints is investigated. Results show that microstructural gradients across BM–HAZ–FZ govern hardness, strain rate sensitivity, and failure modes. While strength increases with strain rate, energy absorption is controlled by ductility, with DP800–DP800 joints showing superior ...
Pankaj Shrivastava, Velaphi Msomi
wiley +1 more source
Influence of surface polyurea coating on the ballistic performance of kevlar fabric
HeliyonWith the increasing lethality of modern weapons, the development of body armor has become increasingly important. The main objective of current research is to make protective gear lighter and increase material ballistic performance.
Xing Li +3 more
doaj +1 more source
Finite Element Analysis of the Ballistic Impact on Auxetic Sandwich Composite Human Body Armor. [PDF]
Materials (Basel), 2022 Shah IA +6 more
europepmc +1 more source
Effect of Different Surface Treatments on Resistance to Abrasive Wear of AISI 4140 Steel
steel research international, EarlyView.This study investigates how different surface treatments affect resistance to abrasive wear of AISI 4140 Steel. The wear rate was significantly higher in samples subjected to conventional treatments than in samples coated using the HVOF process, demonstrating the superior efficiency of coatings applied by thermal spraying in mitigating abrasive wear ...
Everton Freitas de Oliveira +3 more
wiley +1 more source
Excellent ballistic impact resistance of Al0.3CoCrFeNi multi-principal element alloy with unique bimodal microstructure. [PDF]
Sci Rep, 2021 Muskeri S +9 more
europepmc +1 more source
Systems Engineering, EarlyView.ABSTRACT Complex engineered systems routinely face schedule and cost overruns, along with poor post‐deployment performance. Both INCOSE and the U.S. Department of Defense (DoD) have championed Digital Engineering (DE) as a potential remedy, yet most of DE's purported benefits remain anecdotal, and its return on investment (ROI) remains poorly ...
Jannatul Shefa, Taylan G. Topcu
wiley +1 more source