Results 11 to 20 of about 16,028,301 (287)
Low Stress Mechanical Properties of Hydroentangled Fabrics [PDF]
, 2003 Nonwoven fabrics are used in many different applications including wipes, incontinence products, interlinings, blinds, bed linen, protective clothing and others. However, the potential uses of nonwovens in traditional clothing outerwear (e. g. shirtings)
Saleh, Sanaa Salah El-Din Shoukry
core +7 more sources
Bending Collapse Of Rectangular Section Tubes In Relation To The Bus Roll Over Problem [PDF]
, 1979 The thesis is concerned with the theoretical determination of the overall and local effects on the collapse behaviour of bus structures in a roll over situation.
Kecman, Dušan
core +7 more sources
Effect of Board density and industrial wood particles to cement ratio on mechanical and physical properties of wood cement composite boards [PDF]
تحقیقات علوم چوب و کاغذ ایران, 2021 This study was carried out to investigate the effect of two board density levels of 800 kg/m3 and 1100 kg/m3 and two levels of industrial wood to cement ratios of 25:75 and 35:65 on mechanical and physical properties of wood cement composites.
M. Ghofrani, A. Fazeli
doaj +1 more source
Cellulose Nanocrystal-Based Gradient Hydrogel Actuators with Controllable Bending Properties.
Macromolecular rapid communications, 2023 Stimuli-responsive hydrogel actuators are being increasingly used in microtechnology, but typical bilayer hydrogel actuators have significant drawbacks due to weak adhesive interface between the two layers.
Nontarin Roopsung +4 more
semanticscholar +1 more source
Bending properties of deconstructable cross-laminated timber-concrete composite floor elements
Wood Material Science & Engineering, 2022 Design for disassembly using deconstructable connections facilitates recycling and reusing of building materials and, therefore, reduces waste management problems at the end of service life.
M. Derikvand, G. Fink
semanticscholar +1 more source
Buildings, 2022 This study aimed to investigate the effect of layer arrangement on bending properties of CLT panels made from poplar (Populus deltoides L.). A total of 20 three-layer CLT panels with the same dimensions of 1300 × 360 × 48 mm3 (Length, Width, Thickness ...
Akbar Rostampour Haftkhani +1 more
doaj +1 more source
Journal of Natural Fibers, 2022 Recently, economic and ecological pressures have prompted the composites community to intensively pursue environmentally friendly materials. Their applications are usually limited to non-structural parts. Since the fiber reinforced composites have a weak
Yinghai Jin, Guangxian Xu, Jun Hee Song
doaj +1 more source
Design, fabrication and properties of sandwich composites with metamaterial absorbers integrated
Journal of Aeronautical Materials, 2022 In order to achieve a kind of composite material with both wave absorbing property and certain mechanical load bearing function, the metamaterial absorbers and sandwich composite were combined.
RUAN Xinyi +3 more
doaj +1 more source
Construction and Building Materials, 2021 Machine learning (ML)-based models, decision tree and ANFIS, were used to predict the degree of surface checking and bending properties of 30-month weathered thermally modified timber. The results showed that the investigated initial board properties did
Joran van Blokland +4 more
semanticscholar +1 more source
Buildings, 2022 The main strength and elastic properties of structural timber products, such as glued laminated timber (glulam; GLT) and cross-laminated timber (CLT), are usually described via load-bearing models, which use the tensile properties parallel to the grain ...
Raimund Sieder, Reinhard Brandner
doaj +1 more source