Results 111 to 120 of about 181,339 (261)
Experimental design and three-point bending test.
, 2013 The experiment utilized a 2×2×3 factorial design with a total of 12 groups (A). A cartoon of the three-point bending test of a mouse femur and a representative photograph (B).
Suzanne J. Litscher (307201) +4 more
core +1 more source
A Dislocation Perspective on Strength and Toughness in Ceramics
Advanced Engineering Materials, EarlyView.Dislocations in ceramics enjoy a long but yet under‐appreciated history. The three research waves for dislocations in ceramics highlight the topic evolution over the last 90 years. This review focuses on the impact of dislocation on strength and toughness in ceramics.
Xufei Fang
wiley +1 more source
Rekayasa MesinSandwich composites are engineering materials that can be optimized and replaced with metals, mainly applied in aircraft fields because of their high strength-to-weight ratio.
Nurul Lailatul Muzayadah Muzayadah +4 more
doaj +1 more source
Experimental Characterization of Mycelium‐Based Composites Under Multiple Loading Conditions
Advanced Engineering Materials, EarlyView.This study examines the mechanical response of mycelium‐based composites under compression, shear, and tension using mechanical testing and imaging methods. The comparison between unpressed and hot‐pressed specimens shows that hot pressing is associated with higher compression and shear stiffnesses.
Shaghayegh Elahi +5 more
wiley +1 more source
A Bi-Modulus Material Model for Bending Test on NHL3.5 Lime Mortar. [PDF]
Materials (Basel), 2023 Grazzini R, Misseri G, Rovero L.
europepmc +1 more source
Comparison of Triply Periodic Minimal Surface Energy Absorbers Under Uniaxial Compressive Loading
Advanced Engineering Materials, EarlyView.This study investigates LCD 3D printed Triply Periodic Minimal Surface (TPMS) structures as mechanical energy absorbers. By comparing various base designs and layered combinations under uniaxial compression, it identifies that a Diamond‐Gyroid sandwich structure offers superior performance.
Sergej Grednev +2 more
wiley +1 more source
Behaviour of small masonry assemblages reinforced with a steel cord reinforced joint repointing
, 2016 Unreinforced masonry (URM) walls are one of the oldest and most common types of construction elements in the world. However they are susceptible to failure when exposed to overstresses, caused by out-of-plane and in-plane loads.
Edmondson, Vikki +3 more
core
Bending Test for Small-Diameter Timbers [PDF]
, 2019 In the last two decades, the utilisation of small diameter timbers in constructions has gained increasing attention from both researchers and sustainable building enthusiasts.
Dao, Viet Cuong
core
Dynamic Viscoelastic Behavior of Epoxy Asphalt Mixture under Four-Point Bending
BuildingsGiven the dominant failure mode of steel bridge deck pavement layers, which is flexural–tensile damage, the dynamic modulus parameters conventionally determined through uniaxial compression testing are found to be inadequate for the design or performance
Baiqing He +6 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.This article presents an experimental and numerical modal investigation of composite sandwich structures using surfboards as model systems. By comparing different core materials and reinforcement strategies, the study demonstrates how local stiffeners influence vibrational response and introduce characteristic modal features, highlighting modal ...
Brett Connellan +4 more
wiley +1 more source