Acoustic Emission Characteristics during COD Bending Test [PDF]
, 1978 Recentｌy, acoustic emission (AE) has been applied as one of the most useful technique for detecting microscopic flaws and cracks occuring in material. In this paper, a relation between crack opening displacement and acoustic emission characteristics in ...
黒川, 常夫 +2 more
core
Advanced Engineering Materials, EarlyView.Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal +3 more
wiley +1 more source
SensorsWith growing interest in wearable technologies, the development of flexible sensors and products that can monitor the human body while being comfortable to wear is gaining momentum.
Hee-Ji Choi, Youn-Hee Kim
doaj +1 more source
Flatwise to Upright Build Orientations under Three-Point Bending Test of Nylon 12 (PA12) Additively Manufactured by SLS. [PDF]
Polymers (Basel), 2022 Baba MN.
europepmc +1 more source
Design and Analysis of Compression–Torsion Coupling Metamaterials Using the Golden Section Method
Advanced Engineering Materials, EarlyView.A novel compression–torsion metamaterial is engineered using inclined rods and symmetry breaking. To optimize its torsional performance, the golden section method is employed. The mechanical response of the metamaterial is validated through both numerical analysis and experimental validation.
Amirhossein Hassani, Sara Bagherifard
wiley +1 more source
Development of simple bending test device for education and its practice [PDF]
, 2010 In this study, a simple bending test device for education was developed, and the verification test of the device was performed. In addition, the educational practice by using this device was conducted, and the effect of the device on the class was ...
オオウチ, タケシ +7 more
core
Positioning of the hemimandible for three-point bending test.
, 2019 Positioning of the hemimandible for three-point bending test.
Piotr Dobrowolski (2333500) +10 more
core +1 more source
Flexural Behavior of Concrete Slabs Reinforced with Embedded 3D Steel Trusses
BuildingsThis paper presents a proposal for slabs reinforced with 3D steel reinforcements. Two configurations of 3D steel reinforcement, manually fabricated using 4 mm diameter rods, were investigated: cubic and square pyramid truss lattices.
Javier Hernández-Pérez +4 more
doaj +1 more source
Laboratory Investigation of the Low-Temperature Crack Resistance of Wood Tar-Based Rejuvenated Asphalt Mixture Based on the Semi-Circular Bend and Trabecular Bending Test. [PDF]
Materials (Basel), 2022 Liu K, Liu C, Li Q, Jiang K.
europepmc +1 more source
Hybrid Metal–Carbon Ink for Printed Stretchable Temperature Sensors
Advanced Engineering Materials, EarlyView.We prepare conductive inks for temperature sensing with silver flakes and carbon or graphite flakes in a silicone elastomer matrix. Silver dominates the temperature‐dependent conductivity, while the carbon filler network ensures the stability of the conductive pathways and retains function under strain.
Makara Lay +3 more
wiley +1 more source