Results 161 to 170 of about 26,499 (265)

Comparative Radiopacity of Additively Manufactured Permanent and Temporary Resins and Conventional Resin‐Based Composites

open access: yesJournal of Esthetic and Restorative Dentistry, EarlyView.
ABSTRACT Objective This study aimed to evaluate whether radiopacity differs among additively manufactured permanent resins, temporary resins, and conventional resin‐based composites at clinically relevant thicknesses. Materials and Methods Eight dental materials were evaluated and categorized into four groups: additively manufactured permanent resins ...
Sinem Coşkun‐Albayrak   +3 more
wiley   +1 more source

Wettability of saliva substitutes across various denture base fabrication techniques

open access: yesJournal of Prosthodontics, EarlyView.
Abstract Purpose The present study evaluated the contact angles (CAs) of four denture base materials subjected to different surface treatments using deionized water and saliva substitutes. Material and Methods A total of 32 rectangular specimens were manufactured using four different denture base materials: heat‐cured compression molded Lucitone 199 (C)
Paul Mikhail   +3 more
wiley   +1 more source

Transient exposure to bisphenol F in early life affects the metabolic health of adults. [PDF]

open access: yesExposome
Gadara D   +8 more
europepmc   +1 more source

Effect of cleft palate type and manufacturing method on feeding plate adaptation: A volumetric micro‐computed tomography analysis

open access: yesJournal of Prosthodontics, EarlyView.
Abstract Purpose Feeding plates for cleft palate patients have been used by clinicians for many years to temporarily close the oro‐nasal communication until definitive treatment with surgical techniques. The current in vitro study aimed to evaluate the adaptation of the feeding plates manufactured by two different techniques for three cleft types ...
Osman Akıncı   +6 more
wiley   +1 more source

Effect of surface treatments on the bond strength between additively manufactured or injection‐molded high‐performance polymers and titanium

open access: yesJournal of Prosthodontics, EarlyView.
Abstract Purpose To investigate the effect of surface treatment and fabrication techniques of high‐performance polymers on their shear bond strength (SBS) to grade IV titanium. Materials and Methods A total of 120 pre‐milled titanium abutments were sectioned.
Ahmet Serkan Küçükekenci   +3 more
wiley   +1 more source

Activation of NLRP3 Inflammasome in Liver of Long Evans Lactating Rats and Its Perinatal Effects in the Offspring after Bisphenol F Exposure. [PDF]

open access: yesInt J Mol Sci, 2023
Linillos-Pradillo B   +7 more
europepmc   +1 more source

Home - About - Disclaimer - Privacy