Results 81 to 90 of about 41,046 (292)
Micro-lateral extrusion of Zr55Cu30Al10Ni5 bulk metallic glass under low-frequency vibration loading
MATEC Web of Conferences, 2015 The effect of vibration on the micro-forming ability of Zr55Cu30Al10Ni5 bulk metallic glass in its supercooled liquid region was studied. The experiment of micro-extrusion was carried out under different amplitude (38 ∼ 760 N) and different frequency (0 ...
Li Jinyang +3 more
doaj +1 more source
A transferable machine-learning framework linking interstice distribution and plastic heterogeneity in metallic glasses [PDF]
, 2019 When metallic glasses (MGs) are subjected to mechanical loads, the plastic response of atoms is non-uniform. However, the extent and manner in which atomic environment signatures present in the undeformed structure determine this plastic heterogeneity ...
Jain, Anubhav, Wang, Qi
core +3 more sources
Electrical Conductivities of Conductors, Semiconductors, and Their Mixtures at Elevated Temperatures
Advanced Engineering Materials, EarlyView.This article presents a comprehensive review of temperature‐dependent electrical conductivity data for multiple material classes at elevated temperatures, highlighting a persistent conductivity gap between metals and semiconductors in the range of 102$\left(10\right)^{2}$– 107$\left(10\right)^{7}$ S/m. Metal–ceramic irregular metamaterials are proposed
Valentina Torres Nieto, Marcia A. Cooper
wiley +1 more source
Interface-controlled creep in metallic glass composites
, 2017 In this work we present molecular dynamics simulations on the creep behavior of $\rm Cu_{64}Zr_{36}$ metallic glass composites. Surprisingly, all composites exhibit much higher creep rates than the homogeneous glass.
Albe, Karsten +4 more
core +1 more source
Advanced Engineering Materials, EarlyView.This article presents the design, modeling, and characterization of air‐pressure–actuated programmable vibroacoustic metamaterials (PVAMM). The study focuses on leveraging air pressure to dynamically tune resonance frequencies for effective noise attenuation.
William Kaal +2 more
wiley +1 more source
From powders to bulk metallic glass composites
Scientific Reports, 2017 One way to adjust the properties of materials is by changing its microstructure. This concept is not easily applicable on bulk metallic glasses (BMGs), because they do not consist of grains or different phases and so their microstructure is very ...
Lisa Krämer +2 more
doaj +1 more source
Large Compressive Plasticity in a La-Based Glass-Crystal Composite
Metals, 2012 La55Al25Cu10Ni10 metallic glass has been reinforced with 325-mesh Ta particles to obtain ex situ glass-crystal composites. The composites show a high compressive plasticity (40%) with a minor reduction (~8%) in yield strength—a combination unprecedented ...
Shantanu V. Madge +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Phase‐changing liquids enable untethered pneumatic actuation in soft robotics but suffer from volatility and storage challenges. This work reports a simple method to encapsulate Novec 7000 within micron‐thin alginate shells via in situ injection and ionic crosslinking.
Rayan A. M. Basodan +3 more
wiley +1 more source
Scattering mechanical performances for brittle bulk metallic glasses
AIP Advances, 2014 Scattering mechanical performances of brittle La- and Mg-based BMGs are found in the present study. Upon dynamic loading, there exist largely scattered fracture strengths even if the strain rates are under the same order, and the BMG systems are the same.
J. W. Qiao +8 more
doaj +1 more source
Pressure-dependent flow behavior of Zr_(41.2)Ti_(13.8)Cu_(12.5)Ni_(10)Be_(22.5) bulk metallic glass [PDF]
, 2003 An experimental study of the inelastic deformation of bulk metallic glass Zr_(41.2)Ti_(13.8)Cu_(12.5)Ni_(10)Be_(22.5) under multiaxial compression using a confining sleeve technique is presented. In contrast to the catastrophic shear failure (brittle) in
Lu, Jun, Ravichandran, Guruswami
core